From mboxrd@z Thu Jan 1 00:00:00 1970 From: Roy Dragseth Date: Thu, 09 Jan 2003 21:23:11 +0000 Subject: [Linux-ia64] Re: Re: disabling nics using boot options. Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: quoted-printable To: linux-ia64@vger.kernel.org On Thursday 09 January 2003 21:48, Bill Nottingham wrote: > Are there any error messages from the driver? I find this in /var/log/messages Jan 9 20:09:51 compute-1-1 kernel: Error seeking in /dev/kmem Jan 9 20:09:51 compute-1-1 kernel: Symbol #tg3, value 001bc000 Jan 9 20:09:51 compute-1-1 kernel: Error adding kernel module table entry. and this in dmesg: tg3.c:v0.99 (Jun 11, 2002) PCI: Found IRQ 56 for device 20:02.0 divert: allocating divert_blk for eth1 eth1: Tigon3 [partno(BCM95700A6) rev 0105 PHY(5701)] (PCI:66MHz:64-bit)=20 10/100/1 000BaseT Ethernet 00:30:6e:38:99:07 PCI: Found IRQ 65 for device 80:01.0 divert: allocating divert_blk for eth2 eth2: Tigon3 [partno(A6825-60101) rev 0105 PHY(5701)] (PCI:66MHz:64-bit)=20 10/100/ 1000BaseT Ethernet 00:30:6e:2b:cc:05 eth2: Link is up at 1000 Mbps, full duplex. eth2: Flow control is off for TX and off for RX. ACPI: Power Button (FF) [PWRF] ACPI: Sleep Button (FF) [SLPF] eth2: Link is up at 1000 Mbps, full duplex. eth2: Flow control is off for TX and off for RX. I don't really know if these are real error messages. r. --=20 The Computer Center, University of Troms=F8, N-9037 TROMS=D8, Norway. phone:+47 77 64 41 07, fax:+47 77 64 41 00 Roy Dragseth, High Performance Computing System Administrator Direct call: +47 77 64 62 56. email: royd@cc.uit.no