Re: JMicron - hard resetting link

["Gabor FUNK" <FUNK.Gabor@hunetkft.hu>]

>> Since it is not a "switch on and see" problem, I'm not in too good
>> position, so unless someone have a really great idea or observation,
>> I seriously have to consider to replace the MB and probably add
>> some extra sata controllers.
> 
> If you can still do some testing, what happens if you unplug power to
> the failed drive and replug it while the system is still running?  Does
> hotplug event get triggered and the drive gets recognized again?  If so,
> does unplugging and replugging the SATA controller only (w/o powering
> down the drive) achieve the same thing?

I doubt I will start another week of testing without any major changes,
I didn't do drive hotplug, but as for the controllers, they're are all on-
board ones...

I guess new (and different) motherboard and sata controllers cards will
be the next thing to change, 'cause I strongly believe that PSU-s are fine
and should be enough for the system.

G.