Re: [PATCH] libata: add horkage for M88V29

[Damien Le Moal <damien.lemoal@opensource.wdc.com>]

On 6/23/22 16:47, Böszörményi Zoltán wrote:
> 2022. 02. 08. 9:07 keltezéssel, Damien Le Moal írta:
>> On 2/4/22 21:57, zboszor@pr.hu wrote:
>>> From: Zoltán Böszörményi <zboszor@gmail.com>
>>>
>>> This device is a CF card, or possibly an SSD in CF form factor.
>>> It supports NCQ and high speed DMA.
>>>
>>> While it also advertises TRIM support, I/O errors are reported
>>> when the discard mount option fstrim is used. TRIM also fails
>>> when disabling NCQ and not just as an NCQ command.
>>>
>>> TRIM must be disabled for this device.
>>>
>>> Signed-off-by: Zoltán Böszörményi <zboszor@gmail.com>
>>> ---
>>>   drivers/ata/libata-core.c | 1 +
>>>   1 file changed, 1 insertion(+)
>>>
>>> diff --git a/drivers/ata/libata-core.c b/drivers/ata/libata-core.c
>>> index 67f88027680a..4a7f58fcc411 100644
>>> --- a/drivers/ata/libata-core.c
>>> +++ b/drivers/ata/libata-core.c
>>> @@ -4028,6 +4028,7 @@ static const struct ata_blacklist_entry ata_device_blacklist [] = {
>>>   
>>>   	/* devices that don't properly handle TRIM commands */
>>>   	{ "SuperSSpeed S238*",		NULL,	ATA_HORKAGE_NOTRIM, },
>>> +	{ "M88V29*",			NULL,	ATA_HORKAGE_NOTRIM, },
>>>   
>>>   	/*
>>>   	 * As defined, the DRAT (Deterministic Read After Trim) and RZAT
>> Applied to for-5.17-fixes. Thanks !
> 
> Thank you. However, I have second thoughts about this patch.
> The device advertises this:
> 
> # hdparm -iI /dev/sda
> ...
>   Enabled Supported
>      *    Data Set Management TRIM supported (limit 1 block)
> ...
> 
> but the I/O failures always reported higher number of blocks,
> IIRC the attempted number of block was 8 or so.
> 
> Can the kernel limit or split TRIM commands according to the
> advertised limit? If not (or not yet) then the quirk is good for now.

Yes, the kernel does that. See the sysfs queue attributes
discard_max_bytes and discard_max_hw_bytes. What are the values for your
device ? I think that the "limit 1 block" indicated by hdparm is simply to
say that the DSM command (to trim the device) accept only at most a 1
block (512 B) list of sectors to trim. That is not the actual trim limit
for each sector range in that list.

> 
> Best regards,
> Zoltán Böszörményi
> 


-- 
Damien Le Moal
Western Digital Research