* harddisk corruption with 2.5.41bk and tcq enabled
@ 2002-10-12 8:50 Jan Dittmer
2002-10-12 9:06 ` David S. Miller
2002-10-12 9:16 ` Jens Axboe
0 siblings, 2 replies; 5+ messages in thread
From: Jan Dittmer @ 2002-10-12 8:50 UTC (permalink / raw)
To: linux-kernel; +Cc: linux-ide
Hi,
recent tcp additions seem to corrupt harddisk. X/KDE doesn't start up anymore
and 'mount' was broken after reboot. (Debian/unstable, ext3 fs) No Problem
with clean 2.5.41. Will try 2.5.42 now. You need any more information?
jan
Here goes dmesg/config output:
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller at PCI slot 00:07.1
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci00:07.1
ide0: BM-DMA at 0x9000-0x9007, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0x9008-0x900f, BIOS settings: hdc:DMA, hdd:DMA
hda: IC35L060AVVA07-0, ATA DISK drive
hda: DMA disabled
hda: bad special flag: 0x03
hda: tagged command queueing enabled, command queue depth 8
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hdc: SONY CD-RW CRX175E2, ATAPI CD/DVD-ROM drive
hdd: Pioneer DVD-ROM ATAPIModel DVD-104S 012, ATAPI CD/DVD-ROM drive
hdc: DMA disabled
hdd: DMA disabled
ide1 at 0x170-0x177,0x376 on irq 15
hda: host protected area => 1
hda: 120103200 sectors (61493 MB) w/1863KiB Cache, CHS=7476/255/63, UDMA(100)
/dev/ide/host0/bus0/target0/lun0: p1 p2 p3 p4 < p5 p6 >
ide-cd: passing drive hdc to ide-scsi emulation.
hdd: ATAPI DVD-ROM drive, 512kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
Vendor: SONY Model: CD-RW CRX175E2 Rev: S002
Type: CD-ROM ANSI SCSI revision: 02
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0
sr0: scsi3-mmc drive: 40x/40x writer cd/rw xa/form2 cdda tray
[...]
attempt to access beyond end of device
ide0(3,2): rw=0, want=1076371720, limit=19535040
attempt to access beyond end of device
ide0(3,2): rw=0, want=1076261672, limit=19535040
attempt to access beyond end of device
ide0(3,2): rw=0, want=1076240168, limit=19535040
attempt to access beyond end of device
ide0(3,2): rw=0, want=1076243240, limit=19535040
attempt to access beyond end of device
ide0(3,2): rw=0, want=1076335080, limit=19535040
attempt to access beyond end of device
ide0(3,2): rw=0, want=1076262568, limit=19535040
attempt to access beyond end of device
ide0(3,2): rw=0, want=1076262568, limit=19535040
attempt to access beyond end of device
ide0(3,2): rw=0, want=1076262568, limit=19535040
.config:
#
# IDE chipset support/bugfixes
#
# CONFIG_BLK_DEV_CMD640 is not set
# CONFIG_BLK_DEV_CMD640_ENHANCED is not set
# CONFIG_BLK_DEV_ISAPNP is not set
CONFIG_BLK_DEV_IDEPCI=y
# CONFIG_BLK_DEV_GENERIC is not set
CONFIG_IDEPCI_SHARE_IRQ=y
CONFIG_BLK_DEV_IDEDMA_PCI=y
CONFIG_BLK_DEV_IDE_TCQ=y
CONFIG_BLK_DEV_IDE_TCQ_DEFAULT=y
CONFIG_BLK_DEV_IDE_TCQ_DEPTH=8
# CONFIG_BLK_DEV_OFFBOARD is not set
CONFIG_BLK_DEV_IDEDMA_FORCED=y
CONFIG_IDEDMA_PCI_AUTO=y
# CONFIG_IDEDMA_ONLYDISK is not set
CONFIG_BLK_DEV_IDEDMA=y
CONFIG_IDEDMA_PCI_WIP=y
CONFIG_IDEDMA_NEW_DRIVE_LISTINGS=y
CONFIG_BLK_DEV_ADMA=y
# CONFIG_BLK_DEV_AEC62XX is not set
# CONFIG_BLK_DEV_ALI15X3 is not set
# CONFIG_WDC_ALI15X3 is not set
# CONFIG_BLK_DEV_AMD74XX is not set
# CONFIG_AMD74XX_OVERRIDE is not set
# CONFIG_BLK_DEV_CMD64X is not set
# CONFIG_BLK_DEV_CY82C693 is not set
# CONFIG_BLK_DEV_CS5530 is not set
# CONFIG_BLK_DEV_HPT34X is not set
# CONFIG_HPT34X_AUTODMA is not set
# CONFIG_BLK_DEV_HPT366 is not set
# CONFIG_BLK_DEV_PIIX is not set
# CONFIG_BLK_DEV_NFORCE is not set
# CONFIG_BLK_DEV_NS87415 is not set
# CONFIG_BLK_DEV_OPTI621 is not set
# CONFIG_BLK_DEV_PDC202XX_OLD is not set
# CONFIG_PDC202XX_BURST is not set
# CONFIG_BLK_DEV_PDC202XX_NEW is not set
# CONFIG_PDC202XX_FORCE is not set
# CONFIG_BLK_DEV_RZ1000 is not set
# CONFIG_BLK_DEV_SVWKS is not set
# CONFIG_BLK_DEV_SIIMAGE is not set
# CONFIG_BLK_DEV_SIS5513 is not set
# CONFIG_BLK_DEV_SLC90E66 is not set
# CONFIG_BLK_DEV_TRM290 is not set
CONFIG_BLK_DEV_VIA82CXXX=y
# CONFIG_IDE_CHIPSETS is not set
CONFIG_IDEDMA_AUTO=y
# CONFIG_IDEDMA_IVB is not set
# CONFIG_DMA_NONPCI is not set
CONFIG_BLK_DEV_IDE_MODES=y
^ permalink raw reply [flat|nested] 5+ messages in thread
* Re: harddisk corruption with 2.5.41bk and tcq enabled
2002-10-12 8:50 harddisk corruption with 2.5.41bk and tcq enabled Jan Dittmer
@ 2002-10-12 9:06 ` David S. Miller
2002-10-12 9:16 ` Jens Axboe
1 sibling, 0 replies; 5+ messages in thread
From: David S. Miller @ 2002-10-12 9:06 UTC (permalink / raw)
To: jan; +Cc: linux-kernel, linux-ide
From: Jan Dittmer <jan@jandittmer.de>
Date: Sat, 12 Oct 2002 10:50:01 +0200
recent tcp additions
I hope you really mean "tcq" additions.
Nothing that has happened in the TCP networking lately
can corrupt your harddisk. :-)
^ permalink raw reply [flat|nested] 5+ messages in thread
* Re: harddisk corruption with 2.5.41bk and tcq enabled
2002-10-12 8:50 harddisk corruption with 2.5.41bk and tcq enabled Jan Dittmer
2002-10-12 9:06 ` David S. Miller
@ 2002-10-12 9:16 ` Jens Axboe
2002-10-12 11:37 ` Jan Dittmer
2002-10-12 18:40 ` Jan Dittmer
1 sibling, 2 replies; 5+ messages in thread
From: Jens Axboe @ 2002-10-12 9:16 UTC (permalink / raw)
To: Jan Dittmer; +Cc: linux-kernel, linux-ide
On Sat, Oct 12 2002, Jan Dittmer wrote:
> Hi,
>
> recent tcp additions seem to corrupt harddisk. X/KDE doesn't start up anymore
> and 'mount' was broken after reboot. (Debian/unstable, ext3 fs) No Problem
> with clean 2.5.41. Will try 2.5.42 now. You need any more information?
2.5.42 has no changes in this area, so it's probably not safe for you
either.
> Here goes dmesg/config output:
>
> ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
> VP_IDE: IDE controller at PCI slot 00:07.1
> VP_IDE: chipset revision 6
> VP_IDE: not 100% native mode: will probe irqs later
> VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci00:07.1
> ide0: BM-DMA at 0x9000-0x9007, BIOS settings: hda:DMA, hdb:pio
> ide1: BM-DMA at 0x9008-0x900f, BIOS settings: hdc:DMA, hdd:DMA
> hda: IC35L060AVVA07-0, ATA DISK drive
Vancouver, I'm using the very same drive here on the machine where I'm
writing this mail. This could be some odd via interaction.
> [...]
>
> attempt to access beyond end of device
> ide0(3,2): rw=0, want=1076371720, limit=19535040
Any messages _before_ these??
--
Jens Axboe
^ permalink raw reply [flat|nested] 5+ messages in thread
* Re: harddisk corruption with 2.5.41bk and tcq enabled
2002-10-12 9:16 ` Jens Axboe
@ 2002-10-12 11:37 ` Jan Dittmer
2002-10-12 18:40 ` Jan Dittmer
1 sibling, 0 replies; 5+ messages in thread
From: Jan Dittmer @ 2002-10-12 11:37 UTC (permalink / raw)
To: Jens Axboe; +Cc: linux-kernel, linux-ide
> > attempt to access beyond end of device
> > ide0(3,2): rw=0, want=1076371720, limit=19535040
>
At least not ide related. Just ext3 moaning.
I'm just reinstalling debian, e2fsck just killed most of my filesystem :-(
(including old dmesg/config).
I'll give 2.4.42 a try on a fresh install with ext_2_. But I think there
were no changes with respect to ext3 lately?!
jan
> Any messages _before_ these??
>
> --
> Jens Axboe
>
--
portrix.net GmbH
j.dittmer@portrix.net
^ permalink raw reply [flat|nested] 5+ messages in thread
* Re: harddisk corruption with 2.5.41bk and tcq enabled
2002-10-12 9:16 ` Jens Axboe
2002-10-12 11:37 ` Jan Dittmer
@ 2002-10-12 18:40 ` Jan Dittmer
1 sibling, 0 replies; 5+ messages in thread
From: Jan Dittmer @ 2002-10-12 18:40 UTC (permalink / raw)
To: Jens Axboe; +Cc: linux-kernel, linux-ide
> 2.5.42 has no changes in this area, so it's probably not safe for you
> either.
Tried it anyway. Nothing better. Seems to happen also with tcq disabled. I've
for now downgraded to 2.4 ... Don't want to reinstall again.
I don't have a serial console available. So I'm sorry but I can't give you any
further clues. X locks up completly after some minutes, on reboot e2fsck gives a
ton of errors (also with ext2 btw). Or can you point me to something I can try
safely?! Perhaps I'll give 2.5.40 a try again tomorrow. That was the latest
revision working iirc. But for now I'm tired and a bit scared ;-)
jan
^ permalink raw reply [flat|nested] 5+ messages in thread
end of thread, other threads:[~2002-10-12 18:40 UTC | newest]
Thread overview: 5+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2002-10-12 8:50 harddisk corruption with 2.5.41bk and tcq enabled Jan Dittmer
2002-10-12 9:06 ` David S. Miller
2002-10-12 9:16 ` Jens Axboe
2002-10-12 11:37 ` Jan Dittmer
2002-10-12 18:40 ` Jan Dittmer
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).