From: Tejun Heo <htejun@gmail.com>
To: jgarzik@pobox.com, linux-ide@vger.kernel.org
Cc: Tejun Heo <htejun@gmail.com>
Subject: [PATCH 5/6] sata_nv: convert to new EH
Date: Sat, 17 Jun 2006 15:49:56 +0900 [thread overview]
Message-ID: <11505269962838-git-send-email-htejun@gmail.com> (raw)
In-Reply-To: <11505269953650-git-send-email-htejun@gmail.com>
Convert to new EH.
Signed-off-by: Tejun Heo <htejun@gmail.com>
---
drivers/scsi/sata_nv.c | 115 +++++++++++++++++++++++++++++++++++++-----------
1 files changed, 89 insertions(+), 26 deletions(-)
2f2aa6fb450c5bbd2cbf3f1aea1f66e6cd6c5f3e
diff --git a/drivers/scsi/sata_nv.c b/drivers/scsi/sata_nv.c
index 94cb179..2a1bd85 100644
--- a/drivers/scsi/sata_nv.c
+++ b/drivers/scsi/sata_nv.c
@@ -68,6 +68,9 @@ enum {
NV_INT_PORT_SHIFT = 4, /* each port occupies 4 bits */
+ NV_INT_ALL = 0x0f,
+ NV_INT_MASK = NV_INT_DEV,
+
/* INT_CONFIG */
NV_INT_CONFIG = 0x12,
NV_INT_CONFIG_METHD = 0x01, // 0 = INT, 1 = SMI
@@ -88,6 +91,12 @@ static irqreturn_t nv_ck804_interrupt(in
static u32 nv_scr_read (struct ata_port *ap, unsigned int sc_reg);
static void nv_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val);
+static void nv_nf2_freeze(struct ata_port *ap);
+static void nv_nf2_thaw(struct ata_port *ap);
+static void nv_ck804_freeze(struct ata_port *ap);
+static void nv_ck804_thaw(struct ata_port *ap);
+static void nv_error_handler(struct ata_port *ap);
+
enum nv_host_type
{
GENERIC,
@@ -166,14 +175,16 @@ static const struct ata_port_operations
.exec_command = ata_exec_command,
.check_status = ata_check_status,
.dev_select = ata_std_dev_select,
- .phy_reset = sata_phy_reset,
.bmdma_setup = ata_bmdma_setup,
.bmdma_start = ata_bmdma_start,
.bmdma_stop = ata_bmdma_stop,
.bmdma_status = ata_bmdma_status,
.qc_prep = ata_qc_prep,
.qc_issue = ata_qc_issue_prot,
- .eng_timeout = ata_eng_timeout,
+ .freeze = ata_bmdma_freeze,
+ .thaw = ata_bmdma_thaw,
+ .error_handler = nv_error_handler,
+ .post_internal_cmd = ata_bmdma_post_internal_cmd,
.data_xfer = ata_pio_data_xfer,
.irq_handler = nv_generic_interrupt,
.irq_clear = ata_bmdma_irq_clear,
@@ -191,14 +202,16 @@ static const struct ata_port_operations
.exec_command = ata_exec_command,
.check_status = ata_check_status,
.dev_select = ata_std_dev_select,
- .phy_reset = sata_phy_reset,
.bmdma_setup = ata_bmdma_setup,
.bmdma_start = ata_bmdma_start,
.bmdma_stop = ata_bmdma_stop,
.bmdma_status = ata_bmdma_status,
.qc_prep = ata_qc_prep,
.qc_issue = ata_qc_issue_prot,
- .eng_timeout = ata_eng_timeout,
+ .freeze = nv_nf2_freeze,
+ .thaw = nv_nf2_thaw,
+ .error_handler = nv_error_handler,
+ .post_internal_cmd = ata_bmdma_post_internal_cmd,
.data_xfer = ata_pio_data_xfer,
.irq_handler = nv_nf2_interrupt,
.irq_clear = ata_bmdma_irq_clear,
@@ -216,14 +229,16 @@ static const struct ata_port_operations
.exec_command = ata_exec_command,
.check_status = ata_check_status,
.dev_select = ata_std_dev_select,
- .phy_reset = sata_phy_reset,
.bmdma_setup = ata_bmdma_setup,
.bmdma_start = ata_bmdma_start,
.bmdma_stop = ata_bmdma_stop,
.bmdma_status = ata_bmdma_status,
.qc_prep = ata_qc_prep,
.qc_issue = ata_qc_issue_prot,
- .eng_timeout = ata_eng_timeout,
+ .freeze = nv_ck804_freeze,
+ .thaw = nv_ck804_thaw,
+ .error_handler = nv_error_handler,
+ .post_internal_cmd = ata_bmdma_post_internal_cmd,
.data_xfer = ata_pio_data_xfer,
.irq_handler = nv_ck804_interrupt,
.irq_clear = ata_bmdma_irq_clear,
@@ -234,22 +249,11 @@ static const struct ata_port_operations
.host_stop = nv_ck804_host_stop,
};
-/* FIXME: The hardware provides the necessary SATA PHY controls
- * to support ATA_FLAG_SATA_RESET. However, it is currently
- * necessary to disable that flag, to solve misdetection problems.
- * See http://bugme.osdl.org/show_bug.cgi?id=3352 for more info.
- *
- * This problem really needs to be investigated further. But in the
- * meantime, we avoid ATA_FLAG_SATA_RESET to get people working.
- */
static struct ata_port_info nv_port_info[] = {
/* generic */
{
.sht = &nv_sht,
- .host_flags = ATA_FLAG_SATA |
- /* ATA_FLAG_SATA_RESET | */
- ATA_FLAG_SRST |
- ATA_FLAG_NO_LEGACY,
+ .host_flags = ATA_FLAG_SATA | ATA_FLAG_NO_LEGACY,
.pio_mask = NV_PIO_MASK,
.mwdma_mask = NV_MWDMA_MASK,
.udma_mask = NV_UDMA_MASK,
@@ -258,10 +262,7 @@ static struct ata_port_info nv_port_info
/* nforce2/3 */
{
.sht = &nv_sht,
- .host_flags = ATA_FLAG_SATA |
- /* ATA_FLAG_SATA_RESET | */
- ATA_FLAG_SRST |
- ATA_FLAG_NO_LEGACY,
+ .host_flags = ATA_FLAG_SATA | ATA_FLAG_NO_LEGACY,
.pio_mask = NV_PIO_MASK,
.mwdma_mask = NV_MWDMA_MASK,
.udma_mask = NV_UDMA_MASK,
@@ -270,10 +271,7 @@ static struct ata_port_info nv_port_info
/* ck804 */
{
.sht = &nv_sht,
- .host_flags = ATA_FLAG_SATA |
- /* ATA_FLAG_SATA_RESET | */
- ATA_FLAG_SRST |
- ATA_FLAG_NO_LEGACY,
+ .host_flags = ATA_FLAG_SATA | ATA_FLAG_NO_LEGACY,
.pio_mask = NV_PIO_MASK,
.mwdma_mask = NV_MWDMA_MASK,
.udma_mask = NV_UDMA_MASK,
@@ -410,6 +408,71 @@ static void nv_scr_write (struct ata_por
iowrite32(val, (void __iomem *)ap->ioaddr.scr_addr + (sc_reg * 4));
}
+static void nv_nf2_freeze(struct ata_port *ap)
+{
+ unsigned long scr_addr = ap->host_set->ports[0]->ioaddr.scr_addr;
+ int shift = ap->port_no * NV_INT_PORT_SHIFT;
+ u8 mask;
+
+ mask = inb(scr_addr + NV_INT_ENABLE);
+ mask &= ~(NV_INT_ALL << shift);
+ outb(mask, scr_addr + NV_INT_ENABLE);
+}
+
+static void nv_nf2_thaw(struct ata_port *ap)
+{
+ unsigned long scr_addr = ap->host_set->ports[0]->ioaddr.scr_addr;
+ int shift = ap->port_no * NV_INT_PORT_SHIFT;
+ u8 mask;
+
+ outb(NV_INT_ALL << shift, scr_addr + NV_INT_STATUS);
+
+ mask = inb(scr_addr + NV_INT_ENABLE);
+ mask |= (NV_INT_MASK << shift);
+ outb(mask, scr_addr + NV_INT_ENABLE);
+}
+
+static void nv_ck804_freeze(struct ata_port *ap)
+{
+ void __iomem *mmio_base = ap->host_set->mmio_base;
+ int shift = ap->port_no * NV_INT_PORT_SHIFT;
+ u8 mask;
+
+ mask = readb(mmio_base + NV_INT_ENABLE_CK804);
+ mask &= ~(NV_INT_ALL << shift);
+ writeb(mask, mmio_base + NV_INT_ENABLE_CK804);
+}
+
+static void nv_ck804_thaw(struct ata_port *ap)
+{
+ void __iomem *mmio_base = ap->host_set->mmio_base;
+ int shift = ap->port_no * NV_INT_PORT_SHIFT;
+ u8 mask;
+
+ writeb(NV_INT_ALL << shift, mmio_base + NV_INT_STATUS_CK804);
+
+ mask = readb(mmio_base + NV_INT_ENABLE_CK804);
+ mask |= (NV_INT_MASK << shift);
+ writeb(mask, mmio_base + NV_INT_ENABLE_CK804);
+}
+
+static int nv_hardreset(struct ata_port *ap, unsigned int *class)
+{
+ unsigned int dummy;
+
+ /* SATA hardreset fails to retrieve proper device signature on
+ * some controllers. Don't classify on hardreset. For more
+ * info, see http://bugme.osdl.org/show_bug.cgi?id=3352
+ */
+ return sata_std_hardreset(ap, &dummy);
+}
+
+static void nv_error_handler(struct ata_port *ap)
+{
+ ata_bmdma_drive_eh(ap, ata_std_prereset, ata_std_softreset,
+ nv_hardreset, ata_std_postreset);
+}
+
static int nv_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
{
static int printed_version = 0;
--
1.3.2
prev parent reply other threads:[~2006-06-17 6:50 UTC|newest]
Thread overview: 9+ messages / expand[flat|nested] mbox.gz Atom feed top
2006-06-17 6:49 [PATCHSET] sata_nv: convert to new EH and add hotplug support, take 2 Tejun Heo
2006-06-17 6:49 ` [PATCH 2/6] sata_nv: kill struct nv_host_desc and nv_host Tejun Heo
2006-06-17 6:49 ` [PATCH 3/6] sata_nv: simplify constants Tejun Heo
2006-06-17 6:49 ` [PATCH 1/6] sata_nv: kill not-working hotplug code Tejun Heo
2006-06-20 9:09 ` Jeff Garzik
2006-06-20 9:14 ` Tejun Heo
2006-06-17 6:49 ` [PATCH 4/6] sata_nv: better irq handlers Tejun Heo
2006-06-17 6:49 ` [PATCH 6/6] sata_nv: add hotplug support Tejun Heo
2006-06-17 6:49 ` Tejun Heo [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=11505269962838-git-send-email-htejun@gmail.com \
--to=htejun@gmail.com \
--cc=jgarzik@pobox.com \
--cc=linux-ide@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).