Re: [PATCH 8/11] ide-pmac: remove extra good status wait from pmac_ide_do_setfeature()

[Benjamin Herrenschmidt <benh@kernel.crashing.org>]

On Sun, 2007-07-22 at 20:32 +0200, Bartlomiej Zolnierkiewicz wrote:
> Don't check for good device status before executing the command in
> pmac_ide_do_setfeature() (ide_config_drive_speed() doesn't do this).
> 
> It is a job of upper layers to guarantee that the device is ready to
> accept new command before we get here.

I had issues in those areas ... I'd like to keep a warning at least or
something in there for now.

Ben.

> Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
> Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
> ---
>  drivers/ide/ppc/pmac.c |   12 +-----------
>  1 file changed, 1 insertion(+), 11 deletions(-)
> 
> Index: b/drivers/ide/ppc/pmac.c
> ===================================================================
> --- a/drivers/ide/ppc/pmac.c
> +++ b/drivers/ide/ppc/pmac.c
> @@ -547,16 +547,6 @@ pmac_ide_do_setfeature(ide_drive_t *driv
>  	SELECT_DRIVE(drive);
>  	SELECT_MASK(drive, 0);
>  	udelay(1);
> -	/* Get rid of pending error state */
> -	(void) hwif->INB(IDE_STATUS_REG);
> -	/* Timeout bumped for some powerbooks */
> -	if (wait_for_ready(drive, 2000)) {
> -		/* Timeout bumped for some powerbooks */
> -		printk(KERN_ERR "%s: pmac_ide_do_setfeature disk not ready "
> -			"before SET_FEATURE!\n", drive->name);
> -		goto out;
> -	}
> -	udelay(10);
>  	hwif->OUTB(drive->ctl | 2, IDE_CONTROL_REG);
>  	hwif->OUTB(command, IDE_NSECTOR_REG);
>  	hwif->OUTB(SETFEATURES_XFER, IDE_FEATURE_REG);
> @@ -568,7 +558,7 @@ pmac_ide_do_setfeature(ide_drive_t *driv
>  	if (result)
>  		printk(KERN_ERR "%s: pmac_ide_do_setfeature disk not ready "
>  			"after SET_FEATURE !\n", drive->name);
> -out:
> +
>  	SELECT_MASK(drive, 0);
>  	if (result == 0) {
>  		drive->id->dma_ultra &= ~0xFF00;