Re: libata [ata_piix] still no resume from S3 ?

["Rúben Fonseca" <krani1@0x82.com>]

On Thu, 19 Jul 2007, Tejun Heo wrote:

> Rúben Fonseca wrote:
> > On Wed, 18 Jul 2007, Tejun Heo wrote:
> > 
> >>> irq 23: nobody cared (try booting with the "irqpool" option)
> >>>  __report_bad_irq
> >>>  note_interrupt
> >>>  handle_IRQ_event
> >>>  handle_fasteoi_irq
> >>>  do_IRQ
> >>>  do_IRQ
> >>>  irq_exit
> >>>  smp_acpi_timer
> >>>  common_interrupt
> >>>  acpi_pm_read
> >>>  getnstimeofday
> >>>  ktime_get_ts
> >>>  ktime_egt
> >>>  tick_nohz_restart_sched_tick
> >>>  cpu_idle
> >>>  start_kernel
> >>>  unkown_bootoption
> >>>  =====
> >>> handlers:
> >>>  (ata_interrupt [libata])
> >>>  (tifm_7xx1_isr [tifm_7xx1])
> >>> Disabling IRQ #23
> >>> (...)
> >>> ATA: abnormal status 0x7F on port 0x000118cf
> >>>
> >>> And hard drive never cames up.. have to hard reboot the machine..
> >>> Does it help?
> >> Hmmm... That's 'nobody cared' during resume.  Please post the result of
> >> 'lspci -nnvvv'.
> > 
> > 09:04.2 Mass storage controller [0180]: Texas Instruments 5-in-1 Multimedia Card Reader (SD/MMC/MS/MS PRO/xD) [104c:803b]
> > 	Subsystem: Sony Corporation Unknown device [104d:81e6]
> > 	Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
> > 	Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
> > 	Latency: 57 (1750ns min, 1000ns max), Cache Line Size: 64 bytes
> > 	Interrupt: pin C routed to IRQ 23
> > 	Region 0: Memory at dc004000 (32-bit, non-prefetchable) [size=4K]
> > 	Capabilities: [44] Power Management version 2
> > 		Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold-)
> > 		Status: D0 PME-Enable- DSel=0 DScale=0 PME-
> 
> Does the problem still occur if you disable the card reader?

I wish I could disable this card reader. It is built in on the hardware,
and there are no drivers for Linux. There is no option on the BIOS to
disable the device. Is there any way (kernel parameters, magic program,
etc) to disable this device without opening my laptop to cut the wires?
:D

Ruben

-- 
Will work for bandwidth