From: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
To: linux-ide@vger.kernel.org
Cc: linux-kernel@vger.kernel.org,
Sergei Shtylyov <sshtylyov@ru.mvista.com>,
Russell King <rmk@arm.linux.org.uk>
Subject: [PATCH 4/6] ide: remove IDE_TFLAG_NO_SELECT_MASK taskfile flag
Date: Wed, 7 May 2008 19:43:24 +0200 [thread overview]
Message-ID: <200805071943.24296.bzolnier@gmail.com> (raw)
Always call SELECT_MASK(..., 0) in ide_tf_load() (needs to be done
to match ide_set_irq(..., 1)) and then remove IDE_TFLAG_NO_SELECT_MASK
taskfile flag.
This change should only affect hpt366 and icside host drivers since
->maskproc(..., 0) for sgiioc4 is equivalent to ide_set_irq(..., 1).
Cc: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Cc: Russell King <rmk@arm.linux.org.uk>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
---
drivers/ide/ide-cd.c | 4 ++--
drivers/ide/ide-disk.c | 3 +--
drivers/ide/ide-floppy.c | 3 +--
drivers/ide/ide-iops.c | 4 +---
drivers/ide/ide-tape.c | 3 +--
drivers/scsi/ide-scsi.c | 2 +-
include/linux/ide.h | 1 -
7 files changed, 7 insertions(+), 13 deletions(-)
Index: b/drivers/ide/ide-cd.c
===================================================================
--- a/drivers/ide/ide-cd.c
+++ b/drivers/ide/ide-cd.c
@@ -530,8 +530,8 @@ static ide_startstop_t cdrom_start_packe
info->dma = !hwif->dma_ops->dma_setup(drive);
/* set up the controller registers */
- ide_pktcmd_tf_load(drive, IDE_TFLAG_OUT_NSECT | IDE_TFLAG_OUT_LBAL |
- IDE_TFLAG_NO_SELECT_MASK, xferlen, info->dma);
+ ide_pktcmd_tf_load(drive, IDE_TFLAG_OUT_NSECT | IDE_TFLAG_OUT_LBAL,
+ xferlen, info->dma);
if (info->cd_flags & IDE_CD_FLAG_DRQ_INTERRUPT) {
/* waiting for CDB interrupt, not DMA yet. */
Index: b/drivers/ide/ide-disk.c
===================================================================
--- a/drivers/ide/ide-disk.c
+++ b/drivers/ide/ide-disk.c
@@ -198,8 +198,7 @@ static ide_startstop_t __ide_do_rw_disk(
}
memset(&task, 0, sizeof(task));
- task.tf_flags = IDE_TFLAG_NO_SELECT_MASK; /* FIXME? */
- task.tf_flags |= (IDE_TFLAG_TF | IDE_TFLAG_DEVICE);
+ task.tf_flags = IDE_TFLAG_TF | IDE_TFLAG_DEVICE;
if (drive->select.b.lba) {
if (lba48) {
Index: b/drivers/ide/ide-floppy.c
===================================================================
--- a/drivers/ide/ide-floppy.c
+++ b/drivers/ide/ide-floppy.c
@@ -667,8 +667,7 @@ static ide_startstop_t idefloppy_issue_p
if ((pc->flags & PC_FLAG_DMA_RECOMMENDED) && drive->using_dma)
dma = !hwif->dma_ops->dma_setup(drive);
- ide_pktcmd_tf_load(drive, IDE_TFLAG_NO_SELECT_MASK |
- IDE_TFLAG_OUT_DEVICE, bcount, dma);
+ ide_pktcmd_tf_load(drive, IDE_TFLAG_OUT_DEVICE, bcount, dma);
if (dma) {
/* Begin DMA, if necessary */
Index: b/drivers/ide/ide-iops.c
===================================================================
--- a/drivers/ide/ide-iops.c
+++ b/drivers/ide/ide-iops.c
@@ -121,9 +121,7 @@ static void ide_tf_load(ide_drive_t *dri
HIHI = 0xFF;
ide_set_irq(drive, 1);
-
- if ((task->tf_flags & IDE_TFLAG_NO_SELECT_MASK) == 0)
- SELECT_MASK(drive, 0);
+ SELECT_MASK(drive, 0);
if (task->tf_flags & IDE_TFLAG_OUT_DATA) {
u16 data = (tf->hob_data << 8) | tf->data;
Index: b/drivers/ide/ide-tape.c
===================================================================
--- a/drivers/ide/ide-tape.c
+++ b/drivers/ide/ide-tape.c
@@ -1046,8 +1046,7 @@ static ide_startstop_t idetape_issue_pc(
if ((pc->flags & PC_FLAG_DMA_RECOMMENDED) && drive->using_dma)
dma_ok = !hwif->dma_ops->dma_setup(drive);
- ide_pktcmd_tf_load(drive, IDE_TFLAG_NO_SELECT_MASK |
- IDE_TFLAG_OUT_DEVICE, bcount, dma_ok);
+ ide_pktcmd_tf_load(drive, IDE_TFLAG_OUT_DEVICE, bcount, dma_ok);
if (dma_ok)
/* Will begin DMA later */
Index: b/drivers/scsi/ide-scsi.c
===================================================================
--- a/drivers/scsi/ide-scsi.c
+++ b/drivers/scsi/ide-scsi.c
@@ -564,7 +564,7 @@ static ide_startstop_t idescsi_issue_pc(
hwif->sg_mapped = 0;
}
- ide_pktcmd_tf_load(drive, IDE_TFLAG_NO_SELECT_MASK, bcount, dma);
+ ide_pktcmd_tf_load(drive, 0, bcount, dma);
if (dma)
pc->flags |= PC_FLAG_DMA_OK;
Index: b/include/linux/ide.h
===================================================================
--- a/include/linux/ide.h
+++ b/include/linux/ide.h
@@ -854,7 +854,6 @@ extern void ide_end_drive_cmd(ide_drive_
enum {
IDE_TFLAG_LBA48 = (1 << 0),
- IDE_TFLAG_NO_SELECT_MASK = (1 << 1),
IDE_TFLAG_FLAGGED = (1 << 2),
IDE_TFLAG_OUT_DATA = (1 << 3),
IDE_TFLAG_OUT_HOB_FEATURE = (1 << 4),
next reply other threads:[~2008-05-07 17:29 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2008-05-07 17:43 Bartlomiej Zolnierkiewicz [this message]
2008-05-08 20:58 ` [PATCH 4/6] ide: remove IDE_TFLAG_NO_SELECT_MASK taskfile flag Russell King
2008-05-08 21:22 ` Bartlomiej Zolnierkiewicz
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=200805071943.24296.bzolnier@gmail.com \
--to=bzolnier@gmail.com \
--cc=linux-ide@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=rmk@arm.linux.org.uk \
--cc=sshtylyov@ru.mvista.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).