[PATCH 09/21] ht6560b: convert to use ide_timing_find_mode()

[Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>]

There should be no functional changes caused by this patch.

Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
---
 drivers/ide/Kconfig          |    1 +
 drivers/ide/legacy/ht6560b.c |    7 +++----
 2 files changed, 4 insertions(+), 4 deletions(-)

Index: b/drivers/ide/Kconfig
===================================================================
--- a/drivers/ide/Kconfig
+++ b/drivers/ide/Kconfig
@@ -1008,6 +1008,7 @@ config BLK_DEV_DTC2278
 
 config BLK_DEV_HT6560B
 	tristate "Holtek HT6560B support"
+	select IDE_TIMINGS
 	help
 	  This driver is enabled at runtime using the "ht6560b.probe" kernel
 	  boot parameter. It enables support for the secondary IDE interface
Index: b/drivers/ide/legacy/ht6560b.c
===================================================================
--- a/drivers/ide/legacy/ht6560b.c
+++ b/drivers/ide/legacy/ht6560b.c
@@ -216,6 +216,7 @@ static u8 ht_pio2timings(ide_drive_t *dr
 
         if (pio) {
 		unsigned int cycle_time;
+		struct ide_timing *t = ide_timing_find_mode(XFER_PIO_0 + pio);
 
 		cycle_time = ide_pio_cycle_time(drive, pio);
 
@@ -224,10 +225,8 @@ static u8 ht_pio2timings(ide_drive_t *dr
 		 *  actual cycle time for recovery and activity
 		 *  according system bus speed.
 		 */
-		active_time = ide_pio_timings[pio].active_time;
-		recovery_time = cycle_time
-			- active_time
-			- ide_pio_timings[pio].setup_time;
+		active_time = t->active;
+		recovery_time = cycle_time - active_time - t->setup;
 		/*
 		 *  Cycle times should be Vesa bus cycles
 		 */