[PATCH 15/21] opti621: convert to use ide_timing_find_mode()

[Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>]

There should be no functional changes caused by this patch.

Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
---
 drivers/ide/Kconfig       |    1 +
 drivers/ide/pci/opti621.c |   10 +++++-----
 2 files changed, 6 insertions(+), 5 deletions(-)

Index: b/drivers/ide/Kconfig
===================================================================
--- a/drivers/ide/Kconfig
+++ b/drivers/ide/Kconfig
@@ -426,6 +426,7 @@ config BLK_DEV_GENERIC
 config BLK_DEV_OPTI621
 	tristate "OPTi 82C621 chipset enhanced support (EXPERIMENTAL)"
 	depends on EXPERIMENTAL
+	select IDE_TIMINGS
 	select BLK_DEV_IDEPCI
 	help
 	  This is a driver for the OPTi 82C621 EIDE controller.
Index: b/drivers/ide/pci/opti621.c
===================================================================
--- a/drivers/ide/pci/opti621.c
+++ b/drivers/ide/pci/opti621.c
@@ -208,15 +208,15 @@ typedef struct pio_clocks_s {
 static void compute_clocks(int pio, pio_clocks_t *clks)
 {
 	if (pio != PIO_NOT_EXIST) {
-		int adr_setup, data_pls;
+		struct ide_timing *t = ide_timing_find_mode(XFER_PIO_0 + pio);
+		int adr_setup = t->setup, data_pls = t->active;
 		int bus_speed = ide_pci_clk ? ide_pci_clk : 33;
 
-		adr_setup = ide_pio_timings[pio].setup_time;
-		data_pls = ide_pio_timings[pio].active_time;
 		clks->address_time = cmpt_clk(adr_setup, bus_speed);
 		clks->data_time = cmpt_clk(data_pls, bus_speed);
-		clks->recovery_time = cmpt_clk(ide_pio_timings[pio].cycle_time
-			- adr_setup-data_pls, bus_speed);
+		clks->recovery_time = cmpt_clk(t->cycle	- adr_setup - data_pls,
+					       bus_speed);
+
 		if (clks->address_time < 1)
 			clks->address_time = 1;
 		if (clks->address_time > 4)