[PATCH 1/3] ide: mask interrupt in ide_config_drive_speed()

[Sergei Shtylyov <sshtylyov@ru.mvista.com>]

Apparently, there is no sense in unmasking IRQ on the controller when you call
disable_irq_nosync() before doing this, set the nIEN bit afterwards, and then
unmask IRQ again after the command completion, hence 1 passed to SELECT_MASK()
before issuing the command in ide_config_drive_speed() is probably just a typo.

Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>

 drivers/ide/ide-iops.c |    2 +-
 1 files changed, 1 insertion(+), 1 deletion(-)

Index: linux-2.6/drivers/ide/ide-iops.c
===================================================================
--- linux-2.6.orig/drivers/ide/ide-iops.c
+++ linux-2.6/drivers/ide/ide-iops.c
@@ -840,7 +840,7 @@ int ide_config_drive_speed(ide_drive_t *
 	 
 	udelay(1);
 	SELECT_DRIVE(drive);
-	SELECT_MASK(drive, 0);
+	SELECT_MASK(drive, 1);
 	udelay(1);
 	tp_ops->set_irq(hwif, 0);