From: Stanislaw Gruszka <stf_xl@wp.pl>
To: linux-ide@vger.kernel.org, Andrew Victor <avictor.za@gmail.com>
Cc: linux-arm-kernel@lists.arm.linux.org.uk
Subject: [PATCH 3/3 v4] AT91: initialize Compact Flash on AT91SAM9263 cpu
Date: Wed, 18 Feb 2009 11:07:26 +0100 [thread overview]
Message-ID: <200902181107.27095.stf_xl@wp.pl> (raw)
Signed-off-by: Stanislaw Gruszka <stf_xl@wp.pl>
---
arch/arm/mach-at91/at91sam9263_devices.c | 105 ++++++++++++++++++++++++++++++
1 files changed, 105 insertions(+), 0 deletions(-)
diff --git a/arch/arm/mach-at91/at91sam9263_devices.c b/arch/arm/mach-at91/at91sam9263_devices.c
index b753cb8..f048043 100644
--- a/arch/arm/mach-at91/at91sam9263_devices.c
+++ b/arch/arm/mach-at91/at91sam9263_devices.c
@@ -347,6 +347,111 @@ void __init at91_add_device_mmc(short mmc_id, struct at91_mmc_data *data)
void __init at91_add_device_mmc(short mmc_id, struct at91_mmc_data *data) {}
#endif
+/* --------------------------------------------------------------------
+ * Compact Flash (PCMCIA or IDE)
+ * -------------------------------------------------------------------- */
+
+#if defined(CONFIG_AT91_CF) || defined(CONFIG_AT91_CF_MODULE) || \
+ defined(CONFIG_BLK_DEV_IDE_AT91) || defined(CONFIG_BLK_DEV_IDE_AT91_MODULE)
+
+static struct at91_cf_data cf0_data;
+
+static struct resource cf0_resources[] = {
+ [0] = {
+ .start = AT91_CHIPSELECT_4,
+ .end = AT91_CHIPSELECT_4 + SZ_256M - 1,
+ .flags = IORESOURCE_MEM | IORESOURCE_MEM_8AND16BIT,
+ }
+};
+
+static struct platform_device cf0_device = {
+ .id = 0,
+ .dev = {
+ .platform_data = &cf0_data,
+ },
+ .resource = cf0_resources,
+ .num_resources = ARRAY_SIZE(cf0_resources),
+};
+
+static struct at91_cf_data cf1_data;
+
+static struct resource cf1_resources[] = {
+ [0] = {
+ .start = AT91_CHIPSELECT_5,
+ .end = AT91_CHIPSELECT_5 + SZ_256M - 1,
+ .flags = IORESOURCE_MEM | IORESOURCE_MEM_8AND16BIT,
+ }
+};
+
+static struct platform_device cf1_device = {
+ .id = 1,
+ .dev = {
+ .platform_data = &cf1_data,
+ },
+ .resource = cf1_resources,
+ .num_resources = ARRAY_SIZE(cf1_resources),
+};
+
+void __init at91_add_device_cf(struct at91_cf_data *data)
+{
+ unsigned long ebi0_csa;
+ struct platform_device *pdev;
+
+ if (!data)
+ return;
+
+ /*
+ * assign CS4 or CS5 to SMC with Compact Flash logic support,
+ * we assume SMC timings are configured by board code,
+ * except True IDE where timings are controlled by driver
+ */
+ ebi0_csa = at91_sys_read(AT91_MATRIX_EBI0CSA);
+ switch (data->chipselect) {
+ case 4:
+ at91_set_A_periph(AT91_PIN_PD6, 0); /* EBI0_NCS4/CFCS0 */
+ ebi0_csa |= AT91_MATRIX_EBI0_CS4A_SMC_CF1;
+ cf0_data = *data;
+ pdev = &cf0_device;
+ break;
+ case 5:
+ at91_set_A_periph(AT91_PIN_PD7, 0); /* EBI0_NCS5/CFCS1 */
+ ebi0_csa |= AT91_MATRIX_EBI0_CS5A_SMC_CF2;
+ cf1_data = *data;
+ pdev = &cf1_device;
+ break;
+ default:
+ printk(KERN_ERR "AT91 CF: bad chip-select requested (%u)\n",
+ data->chipselect);
+ return;
+ }
+ at91_sys_write(AT91_MATRIX_EBI0CSA, ebi0_csa);
+
+ if (data->det_pin) {
+ at91_set_gpio_input(data->det_pin, 1);
+ at91_set_deglitch(data->det_pin, 1);
+ }
+
+ if (data->irq_pin) {
+ at91_set_gpio_input(data->irq_pin, 1);
+ at91_set_deglitch(data->irq_pin, 1);
+ }
+
+ if (data->vcc_pin)
+ /* initially off */
+ at91_set_gpio_output(data->vcc_pin, 0);
+
+ /* enable EBI controlled pins */
+ at91_set_A_periph(AT91_PIN_PD5, 1); /* NWAIT */
+ at91_set_A_periph(AT91_PIN_PD8, 0); /* CFCE1 */
+ at91_set_A_periph(AT91_PIN_PD9, 0); /* CFCE2 */
+ at91_set_A_periph(AT91_PIN_PD14, 0); /* CFNRW */
+
+ pdev->name = (data->flags & AT91_CF_TRUE_IDE) ? "at91_ide" : "at91_cf";
+ platform_device_register(pdev);
+}
+#else
+void __init at91_add_device_cf(struct at91_cf_data *data) {}
+#endif
/* --------------------------------------------------------------------
* NAND / SmartMedia
--
1.5.2.5
next reply other threads:[~2009-02-18 10:07 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-02-18 10:07 Stanislaw Gruszka [this message]
2009-03-01 19:11 ` [PATCH 3/3 v4] AT91: initialize Compact Flash on AT91SAM9263 cpu Sergei Shtylyov
2009-03-02 16:33 ` Bartlomiej Zolnierkiewicz
2009-03-02 19:54 ` Andrew Victor
2009-03-05 13:48 ` Bartlomiej Zolnierkiewicz
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=200902181107.27095.stf_xl@wp.pl \
--to=stf_xl@wp.pl \
--cc=avictor.za@gmail.com \
--cc=linux-arm-kernel@lists.arm.linux.org.uk \
--cc=linux-ide@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).