[PATCH 5/5] ata: ahci: Do not read per port area for unimplemented ports

[Niklas Cassel <cassel@kernel.org>]

An AHCI HBA specifies the number of ports is supports using CAP.NP.
The HBA is free to only make a subset of the number of ports available
using the PI (Ports Implemented) register.

libata currently creates dummy ports for HBA ports that are provided by
the HBA, but which are marked as "unavailable" using the PI register.

Each port will have per port area of registers in the HBA, regardless if
the port is marked as "unavailable" or not using the PI register.

ahci_mark_external_port() currently reads this per port area or registers
using readl() to see if the port is marked as external/hotplug-capable.

However, AHCI 1.3.1, section "3.1.4 Offset 0Ch: PI – Ports Implemented"
states: "Software must not read or write to registers within unavailable
ports."

Thus, make sure that we only call ahci_mark_external_port() and
ahci_update_initial_lpm_policy() for ports that are implemented.

For a libata perspective, this should not change anything related to LPM,
as dummy ports do not provide any ap->ops (they do not have a .set_lpm()
callback), so even if EH were to call .set_lpm() on a dummy port, it was
already a no-op.

Fixes: f7131935238d ("ata: ahci: move marking of external port earlier")
Signed-off-by: Niklas Cassel <cassel@kernel.org>
---
 drivers/ata/ahci.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/ata/ahci.c b/drivers/ata/ahci.c
index 7a7f88b3fa2b..931d0081169b 100644
--- a/drivers/ata/ahci.c
+++ b/drivers/ata/ahci.c
@@ -2094,13 +2094,13 @@ static int ahci_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
 		if (ap->flags & ATA_FLAG_EM)
 			ap->em_message_type = hpriv->em_msg_type;
 
-		ahci_mark_external_port(ap);
-
-		ahci_update_initial_lpm_policy(ap);
-
 		/* disabled/not-implemented port */
-		if (!(hpriv->port_map & (1 << i)))
+		if (!(hpriv->port_map & (1 << i))) {
 			ap->ops = &ata_dummy_port_ops;
+		} else {
+			ahci_mark_external_port(ap);
+			ahci_update_initial_lpm_policy(ap);
+		}
 	}
 
 	/* apply workaround for ASUS P5W DH Deluxe mainboard */
-- 
2.52.0