From mboxrd@z Thu Jan 1 00:00:00 1970 From: Tejun Heo Subject: Re: SOLVED: DriveStatusError BadCRC Date: Wed, 10 Aug 2005 19:25:40 +0900 Message-ID: <42F9D624.6020005@gmail.com> References: <42D7AA47000408B7@mail-5.mail.tiscali.sys> Mime-Version: 1.0 Content-Type: text/plain; charset=ISO-8859-1; format=flowed Content-Transfer-Encoding: 7bit Return-path: Received: from wproxy.gmail.com ([64.233.184.198]:38243 "EHLO wproxy.gmail.com") by vger.kernel.org with ESMTP id S932543AbVHJKZt (ORCPT ); Wed, 10 Aug 2005 06:25:49 -0400 Received: by wproxy.gmail.com with SMTP id i20so105142wra for ; Wed, 10 Aug 2005 03:25:46 -0700 (PDT) In-Reply-To: <42D7AA47000408B7@mail-5.mail.tiscali.sys> Sender: linux-ide-owner@vger.kernel.org List-Id: linux-ide@vger.kernel.org To: sampei02@tiscali.it Cc: Erik Slagter , linux-ide@vger.kernel.org sampei02@tiscali.it wrote: > I replaced 80 wire flat cable with another 40 wire cable. > In this way I have no errors but now UDMA mode is set to 2 value. > I'm sure that MOTHERBOARD supports UDMA ATA/33/66/100 BUS IDE ports. > What do you think ? [sticking nose in...] In that case, it could be one of... #1 faulty cable, try another 80c cable #2 only one device gets attached to the cable but it's using the middle connector. You need to use the connector at the end of cable when you connect only one device. (I think it became a requirement w/ newer transfer modes. No? still recommendation?) #3 faulty IDE controller (or faulty traces from the controller to cable) #4 faulty drive My bet is on #1 or #2. -- tejun