Re: Issues with sata_nv and 2 disks under 2.6.16 and 2.6.17-rc2

[Roger Heflin <rheflin@atipa.com>]

Emmanuel Fleury wrote:
> Hi,
> 
> Roger Heflin wrote:
>>> ata1: command 0xc8 timeout, stat 0x50 host_stat 0x24
>>> ata1: status=0x50 { DriveReady SeekComplete }
>>> sda: Current: sense key: No Sense
>>>     Additional sense: No additional sense information
>>> Info fld=0x3481ff
>>> ata2: command 0xc8 timeout, stat 0x50 host_stat 0x24
>>> ata2: status=0x50 { DriveReady SeekComplete }
>>> sdb: Current: sense key: No Sense
>>>     Additional sense: No additional sense information
>>> Info fld=0x166ff
>>> ata1: command 0xc8 timeout, stat 0x50 host_stat 0x24
>>> ata1: status=0x50 { DriveReady SeekComplete }
>>> sda: Current: sense key: No Sense
>>>     Additional sense: No additional sense information
>>> Info fld=0x3482ff
>>> ata2: command 0xc8 timeout, stat 0x50 host_stat 0x24
>>> ata2: status=0x50 { DriveReady SeekComplete }
>>> sdb: Current: sense key: No Sense
>>>     Additional sense: No additional sense information
>>> Info fld=0x167ff
>>> ata1: command 0xca timeout, stat 0x50 host_stat 0x24
>>> ata1: status=0x50 { DriveReady SeekComplete }
> 
> Can you try to set the following config options as module:
> 
> Device Drivers  --->
>   SCSI device support  --->
>     SCSI low-level drivers  --->
>       AHCI SATA support
> 
> And
> 
> Device Drivers  --->
>   SCSI device support  --->
>     SCSI low-level drivers  --->
>       NVIDIA SATA support
>

Both are already build as modules, so the failure was with
them as modules.   I used the default type of config setup
from FC5 kernels which loves to build everything as
modules, since FC5 gets annoyed with things being build it.

                             Roger