[PATCH] sata_nv: handle SError status indication

[Robert Hancock <hancockr@shaw.ca>]

ADMA-capable controllers provide a bit in the status register that appears
to indicate that the controller detected an SError condition. Update sata_nv
to detect this and trigger error handling in order to handle the fault.

Signed-off-by: Robert Hancock <hancockr@shaw.ca>

--- drivers/ata/sata_nv.c.before_serror	2007-02-11 17:49:27.000000000 -0600
+++ drivers/ata/sata_nv.c	2007-02-11 17:54:39.000000000 -0600
@@ -827,7 +827,8 @@ static irqreturn_t nv_adma_interrupt(int
 			/* freeze if hotplugged or controller error */
 			if (unlikely(status & (NV_ADMA_STAT_HOTPLUG |
 					       NV_ADMA_STAT_HOTUNPLUG |
-					       NV_ADMA_STAT_TIMEOUT))) {
+					       NV_ADMA_STAT_TIMEOUT |
+					       NV_ADMA_STAT_SERROR))) {
 				struct ata_eh_info *ehi = &ap->eh_info;
 
 				ata_ehi_clear_desc(ehi);
@@ -841,6 +842,9 @@ static irqreturn_t nv_adma_interrupt(int
 				} else if (status & NV_ADMA_STAT_HOTUNPLUG) {
 					ata_ehi_hotplugged(ehi);
 					ata_ehi_push_desc(ehi, ": hot unplug");
+				} else if (status & NV_ADMA_STAT_SERROR) {
+					/* let libata analyze SError and figure out the cause */
+					ata_ehi_push_desc(ehi, ": SError");
 				}
 				ata_port_freeze(ap);
 				continue;