Re: [PATCH] ata: add Buddha PATA controller driver

John Paul Adrian Glaubitz
2018-10-25T19:38:03Z

Hi!

Sorry for the delay!

On 10/18/18 2:29 PM, Bartlomiej Zolnierkiewicz wrote:
> John, please test if possible..
Driver loads and detects hard drive connected to it:

[ 256.110000] zorro zorro3: Buddha IDE controller
[ 256.430000] scsi host2: pata_buddha
[ 256.580000] scsi host3: pata_buddha
[ 256.590000] ata2: PATA max PIO4 cmd 0xeb0000 ctl 0xeb091a irq 2
[ 256.600000] ata3: PATA max PIO4 cmd 0xeb0000 ctl 0xeb0b1a irq 2
[ 256.790000] ata2.00: ATA-6: ST380011A, 8.01, max UDMA/100
[ 256.810000] ata2.00: 156301488 sectors, multi 16: LBA48
[ 256.820000] ata2.00: configured for PIO
[ 256.870000] scsi 2:0:0:0: Direct-Access ATA ST380011A 8.01 PQ: 0 ANSI: 5
[ 257.080000] sd 2:0:0:0: [sdc] 156301488 512-byte logical blocks: (80.0 GB/74.5 GiB)
[ 257.170000] sd 2:0:0:0: [sdc] Write Protect is off
[ 257.190000] sd 2:0:0:0: [sdc] Mode Sense: 00 3a 00 00
[ 257.330000] sd 2:0:0:0: [sdc] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 257.960000] sd 2:0:0:0: [sdc] Attached SCSI disk

I was then able to create an MS-DOS partition table on the disk and create
an ext2 filesystem. I copied some files onto the partition which worked
without any problems.

Tested-by: John Paul Adrian Glaubitz <glaubitz@physik.fu-berlin.de>

Michael wants to make some changes to the driver though, I think. He has access
to the Amiga 4000, in any case, so he can also test them.

Adrian

--
.''`. John Paul Adrian Glaubitz
: :' : Debian Developer - glaubitz@debian.org
`. `' Freie Universitaet Berlin - glaubitz@physik.fu-berlin.de
`- GPG: 62FF 8A75 84E0 2956 9546 0006 7426 3B37 F5B5 F913