Re: [PATCH v3 3/3] iio: accel: BMC150: add support for other Bosch chips

[Joe Perches <joe@perches.com>]

On Mon, 2014-09-01 at 12:11 +0300, Laurentiu Palcu wrote:
> The following chips are either similar or have only the resolution
> different. Hence, change this driver to support these chips too:
> 
> BMI055  - combo chip (accelerometer part is identical to BMC150's)
> BMA255  - identical to BMC150's accelerometer
> BMA222E - 8 bit resolution
> BMA250E - 10 bit resolution
> BMA280  - 14 bit resolution
> 
> Additionally:
>  * add bmc150_accel_match_acpi_device() function to check that the device
>    has been enumerated through ACPI;
>  * rename bmc150_accel_acpi_gpio_probe() to bmc150_accel_gpio_probe()
>    since the ACPI matching has been moved to the new function.  Also, this
>    will allow for the GPIO matching to be done against a device tree too, not only
>    ACPI tree;
[]
> diff --git a/drivers/iio/accel/bmc150-accel.c b/drivers/iio/accel/bmc150-accel.c
[]
> @@ -647,12 +659,13 @@ static int bmc150_accel_read_raw(struct iio_dev *indio_dev,
>  		{
>  			int i;
>  
> -			for (i = 0; i < ARRAY_SIZE(bmc150_accel_scale_table);
> -									 ++i) {
> -				if (bmc150_accel_scale_table[i].range ==
> +			for (i = 0;
> +			     i < ARRAY_SIZE(data->chip_info->scale_table);
> +			     ++i) {
> +				if (data->chip_info->scale_table[i].range ==
>  								data->range) {
>  					*val2 =
> -					bmc150_accel_scale_table[i].scale;
> +					data->chip_info->scale_table[i].scale;
>  					return IIO_VAL_INT_PLUS_MICRO;
>  				}
>  			}

This looks like it would read a lot better with
a temporary for data->chip_info->scale_table[i]

so these could become:

			for (i = 0; i < etc; i++) {
				type *temp = &data->chip_info->scale_table[i];
				if (temp->range == data->range) {
					*val2 = temp->scale;
					return IIO_VAL_INT_PLUS_MICRO;
				}

Maybe all the bmc150_ variable names could be removed.
The prefixes don't seem to serve a purpose other than
to make the code longer.

The filename could be changed to be more generic.