From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: From: Linus Walleij To: Jonathan Cameron , linux-iio@vger.kernel.org, Akinobu Mita , "H. Nikolaus Schaller" , Matt Ranostay Cc: Christoph Mair , Vlad Dogaru , Hartmut Knaack , Marek Belisko , Eric Andersson , Neil Brown , Linus Walleij Subject: [PATCH 3/9 v2] iio: pressure: bmp280: add reset GPIO line handling Date: Wed, 22 Jun 2016 22:53:33 +0200 Message-Id: <1466628819-29784-4-git-send-email-linus.walleij@linaro.org> In-Reply-To: <1466628819-29784-1-git-send-email-linus.walleij@linaro.org> References: <1466628819-29784-1-git-send-email-linus.walleij@linaro.org> List-ID: On the APQ8060 Dragonboard the reset line to the BMP058 pressure sensor is not deasserted on boot, so the driver needs to handle this. For a simple GPIO line supplied as a descriptor (from a board file, device tree or ACPI) this does the trick. Signed-off-by: Linus Walleij --- drivers/iio/pressure/bmp280.c | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/drivers/iio/pressure/bmp280.c b/drivers/iio/pressure/bmp280.c index 655e888ef8f9..f7fd98e93850 100644 --- a/drivers/iio/pressure/bmp280.c +++ b/drivers/iio/pressure/bmp280.c @@ -23,6 +23,7 @@ #include #include #include +#include /* BMP280 specific registers */ #define BMP280_REG_HUMIDITY_LSB 0xFE @@ -1024,6 +1025,7 @@ static int bmp280_probe(struct i2c_client *client, struct iio_dev *indio_dev; struct bmp280_data *data; unsigned int chip_id; + struct gpio_desc *gpiod; indio_dev = devm_iio_device_alloc(&client->dev, sizeof(*data)); if (!indio_dev) @@ -1063,6 +1065,14 @@ static int bmp280_probe(struct i2c_client *client, return -EINVAL; } + /* Bring chip out of reset if there is an assigned GPIO line */ + gpiod = devm_gpiod_get(&client->dev, "reset", GPIOD_OUT_HIGH); + /* Deassert the signal */ + if (!IS_ERR(gpiod)) { + dev_info(&client->dev, "release reset\n"); + gpiod_set_value(gpiod, 0); + } + data->regmap = devm_regmap_init_i2c(client, data->chip_info->regmap_config); if (IS_ERR(data->regmap)) { -- 2.4.11