Re: [PATCH 1/2] dt-bindings: iio: ad74413r: allow setting sink current for digital input

[Rob Herring <robh@kernel.org>]

On Thu, 02 Mar 2023 14:49:20 +0100, Rasmus Villemoes wrote:
> Depending on the actual hardware wired up to a digital input channel,
> it may be necessary to configure the ad74413r to sink a small
> current. For example, in the case of a simple mechanical switch, the
> charge on the external 68 nF capacitor (cf. the data sheet's Figure
> 34) will keep the channel as reading high even after the switch is
> turned off again.
> 
> Signed-off-by: Rasmus Villemoes <linux@rasmusvillemoes.dk>
> ---
>  .../devicetree/bindings/iio/addac/adi,ad74413r.yaml    | 10 ++++++++++
>  1 file changed, 10 insertions(+)
> 

My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
on your patch (DT_CHECKER_FLAGS is new in v5.13):

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/iio/addac/adi,ad74413r.yaml: patternProperties:^channel@[0-3]$:properties:drive-strength-microamp: '$ref' should not be valid under {'const': '$ref'}
	hint: Standard unit suffix properties don't need a type $ref
	from schema $id: http://devicetree.org/meta-schemas/core.yaml#

doc reference errors (make refcheckdocs):

See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230302134922.1120217-2-linux@rasmusvillemoes.dk

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.