Re: [PATCH v2 2/6] iio: adc: ads1015: Balance runtime pm + pm_runtime_resume_and_get()

[Jonathan Cameron <jic23@kernel.org>]

On Wed, 16 Jun 2021 09:15:55 +0200
Mauro Carvalho Chehab <mchehab+huawei@kernel.org> wrote:

> Em Sun, 16 May 2021 17:20:59 +0100
> Jonathan Cameron <jic23@kernel.org> escreveu:
> 
> > From: Jonathan Cameron <Jonathan.Cameron@huawei.com>
> > 
> > The call to pm_runtime_put_noidle() in remove() is not balancing a
> > counter increment.  Note this doesn't matter as the runtime pm core
> > will not allow the counter to go negative.  However, it is confusing
> > to the reader so let's remove it.
> > 
> > The pm_runtime_resume_and_get() replacement was found using coccicheck
> > script under review at:
> > https://lore.kernel.org/lkml/20210427141946.2478411-1-Julia.Lawall@inria.fr/
> > 
> > This is a prequel to taking a closer look at the runtime pm in IIO drivers
> > in general.
> > 
> > Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>  
> 
> LGTM.
> 
> Reviewed-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
Applied
> 
> > ---
> >  drivers/iio/adc/ti-ads1015.c | 5 +----
> >  1 file changed, 1 insertion(+), 4 deletions(-)
> > 
> > diff --git a/drivers/iio/adc/ti-ads1015.c b/drivers/iio/adc/ti-ads1015.c
> > index 5b828428be77..b0352e91ac16 100644
> > --- a/drivers/iio/adc/ti-ads1015.c
> > +++ b/drivers/iio/adc/ti-ads1015.c
> > @@ -323,9 +323,7 @@ static int ads1015_set_power_state(struct ads1015_data *data, bool on)
> >  	struct device *dev = regmap_get_device(data->regmap);
> >  
> >  	if (on) {
> > -		ret = pm_runtime_get_sync(dev);
> > -		if (ret < 0)
> > -			pm_runtime_put_noidle(dev);
> > +		ret = pm_runtime_resume_and_get(dev);
> >  	} else {
> >  		pm_runtime_mark_last_busy(dev);
> >  		ret = pm_runtime_put_autosuspend(dev);
> > @@ -1070,7 +1068,6 @@ static int ads1015_remove(struct i2c_client *client)
> >  
> >  	pm_runtime_disable(&client->dev);
> >  	pm_runtime_set_suspended(&client->dev);
> > -	pm_runtime_put_noidle(&client->dev);
> >  
> >  	/* power down single shot mode */
> >  	return ads1015_set_conv_mode(data, ADS1015_SINGLESHOT);  
> 
> 
> 
> Thanks,
> Mauro