[PATCH v1 2/2] iio: imu: st_lsm6dsx: Remove useless dev_fwnode() calls

[Andy Shevchenko <andy.shevchenko@gmail.com>]

The device property APIs designed that way that they will return an error when
there is no valid fwnode provided. Moreover, the check for NULL of dev_fwnode()
is not fully correct as in some (currently rare) cases it may contain an error
pointer. This is not a problem anyway (see keyword 'valid' above) that's why
the code works properly even without this change.

Signed-off-by: Andy Shevchenko <andy.shevchenko@gmail.com>
---
 drivers/iio/imu/st_lsm6dsx/st_lsm6dsx_core.c | 23 +++++---------------
 1 file changed, 6 insertions(+), 17 deletions(-)

diff --git a/drivers/iio/imu/st_lsm6dsx/st_lsm6dsx_core.c b/drivers/iio/imu/st_lsm6dsx/st_lsm6dsx_core.c
index 722b43f9203b..a7760c000c8c 100644
--- a/drivers/iio/imu/st_lsm6dsx/st_lsm6dsx_core.c
+++ b/drivers/iio/imu/st_lsm6dsx/st_lsm6dsx_core.c
@@ -2127,25 +2127,15 @@ static const struct iio_info st_lsm6dsx_gyro_info = {
 	.write_raw_get_fmt = st_lsm6dsx_write_raw_get_fmt,
 };
 
-static int st_lsm6dsx_get_drdy_pin(struct st_lsm6dsx_hw *hw, int *drdy_pin)
-{
-	struct device *dev = hw->dev;
-
-	if (!dev_fwnode(dev))
-		return -EINVAL;
-
-	return device_property_read_u32(dev, "st,drdy-int-pin", drdy_pin);
-}
-
 static int
 st_lsm6dsx_get_drdy_reg(struct st_lsm6dsx_hw *hw,
 			const struct st_lsm6dsx_reg **drdy_reg)
 {
+	struct device *dev = hw->dev;
 	int err = 0, drdy_pin;
 
-	if (st_lsm6dsx_get_drdy_pin(hw, &drdy_pin) < 0) {
+	if (device_property_read_u32(dev, "st,drdy-int-pin", drdy_pin) < 0) {
 		struct st_sensors_platform_data *pdata;
-		struct device *dev = hw->dev;
 
 		pdata = (struct st_sensors_platform_data *)dev->platform_data;
 		drdy_pin = pdata ? pdata->drdy_int_pin : 1;
@@ -2180,7 +2170,7 @@ static int st_lsm6dsx_init_shub(struct st_lsm6dsx_hw *hw)
 	hub_settings = &hw->settings->shub_settings;
 
 	pdata = (struct st_sensors_platform_data *)dev->platform_data;
-	if ((dev_fwnode(dev) && device_property_read_bool(dev, "st,pullups")) ||
+	if (device_property_read_bool(dev, "st,pullups") ||
 	    (pdata && pdata->pullups)) {
 		if (hub_settings->pullup_en.sec_page) {
 			err = st_lsm6dsx_set_page(hw, true);
@@ -2565,7 +2555,7 @@ static int st_lsm6dsx_irq_setup(struct st_lsm6dsx_hw *hw)
 		return err;
 
 	pdata = (struct st_sensors_platform_data *)dev->platform_data;
-	if ((dev_fwnode(dev) && device_property_read_bool(dev, "drive-open-drain")) ||
+	if (device_property_read_bool(dev, "drive-open-drain") ||
 	    (pdata && pdata->open_drain)) {
 		reg = &hw->settings->irq_config.od;
 		err = regmap_update_bits(hw->regmap, reg->addr, reg->mask,
@@ -2693,8 +2683,7 @@ int st_lsm6dsx_probe(struct device *dev, int irq, int hw_id,
 
 	hub_settings = &hw->settings->shub_settings;
 	if (hub_settings->master_en.addr &&
-	    (!dev_fwnode(dev) ||
-	     !device_property_read_bool(dev, "st,disable-sensor-hub"))) {
+	    !device_property_read_bool(dev, "st,disable-sensor-hub")) {
 		err = st_lsm6dsx_shub_probe(hw, name);
 		if (err < 0)
 			return err;
@@ -2735,7 +2724,7 @@ int st_lsm6dsx_probe(struct device *dev, int irq, int hw_id,
 			return err;
 	}
 
-	if ((dev_fwnode(dev) && device_property_read_bool(dev, "wakeup-source")) ||
+	if (device_property_read_bool(dev, "wakeup-source") ||
 	    (pdata && pdata->wakeup_source))
 		device_init_wakeup(dev, true);
 
-- 
2.46.0