[PATCH v3 1/2] dt-bindings: iio: light: bh1750: Add reset-gpios property

[Sergio Perez <sergio@pereznus.es>]

Some BH1750 sensors require a hardware reset via GPIO before they can
be properly detected on the I2C bus. Add a new reset-gpios property
to the binding to support this functionality.

The reset-gpios property allows specifying a GPIO that will be toggled
during driver initialization to reset the sensor.

Signed-off-by: Sergio Perez <sergio@pereznus.es>
---
 Documentation/devicetree/bindings/iio/light/bh1750.yaml | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/Documentation/devicetree/bindings/iio/light/bh1750.yaml b/Documentation/devicetree/bindings/iio/light/bh1750.yaml
index 1a88b3c253d5..f7a8dcd7d2a1 100644
--- a/Documentation/devicetree/bindings/iio/light/bh1750.yaml
+++ b/Documentation/devicetree/bindings/iio/light/bh1750.yaml
@@ -24,6 +24,10 @@ properties:
   reg:
     maxItems: 1
 
+  reset-gpios:
+    description: GPIO connected to the sensor's reset line (active low)
+    maxItems: 1
+
 required:
   - compatible
   - reg
@@ -39,6 +43,7 @@ examples:
       light-sensor@23 {
         compatible = "rohm,bh1750";
         reg = <0x23>;
+        reset-gpios = <&gpio2 17 0>;
       };
     };
 
-- 
2.43.0