From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: from smtp-out-148.synserver.de ([212.40.185.148]:1100 "EHLO smtp-out-148.synserver.de" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1750711Ab3B0QFi (ORCPT ); Wed, 27 Feb 2013 11:05:38 -0500 Message-ID: <512E2F31.8000604@metafoo.de> Date: Wed, 27 Feb 2013 17:07:13 +0100 From: Lars-Peter Clausen MIME-Version: 1.0 To: Chris Micali CC: "linux-iio@vger.kernel.org" Subject: Re: IIO Drivers References: <26387F1A648A4D3D9BB4142C4F0AAE98@gmail.com> In-Reply-To: <26387F1A648A4D3D9BB4142C4F0AAE98@gmail.com> Content-Type: text/plain; charset=UTF-8 Sender: linux-iio-owner@vger.kernel.org List-Id: linux-iio@vger.kernel.org On 02/26/2013 08:56 PM, Chris Micali wrote: > Hello Lars, > > I'm doing a bit of hacking on a IIO driver based on some of your drivers on a 3.8 kernel (specifically writing a driver for a TI SPI adc.) I've been able to get a driver up and working such that I can read directly from the in_voltage0_raw on sysfs and get the correct values but I can't seem to get buffered access working (via iio_cmdsrv.) I've had a hard time finding any docs on this stuff and I was wondering if you could give me any pointers on where to look or who else perhaps to ask about this stuff? Any pointers would be very much appreciated! > > Thanks, > Chris Hi, I'm afraid except for the the documentation in drivers/staging/iio/Documentation/, the kernel doc comments and the skeleton driver (drivers/staging/iio/iio_simple_dummy*) there is not much additional documentation available. The general place to ask questions about IIO is the IIO mailinglist. I've put it on CC, hope you don't mind. I think we can help you best if you post your code. - Lars