* [PULL] Third set of IIO new device support, features and cleanups for the 4.6 cycle.
@ 2016-02-28 17:06 Jonathan Cameron
0 siblings, 0 replies; only message in thread
From: Jonathan Cameron @ 2016-02-28 17:06 UTC (permalink / raw)
To: Greg KH; +Cc: linux-iio@vger.kernel.org
The following changes since commit 1d427da1d7f9f81c4f5439c9610683d3cb9c1921:
Platform: goldfish: goldfish_pipe.c: Add DMA support using managed version (2016-02-14 17:43:05 -0800)
are available in the git repository at:
git://git.kernel.org/pub/scm/linux/kernel/git/jic23/iio.git tags/iio-for-4.6c
for you to fetch changes up to ac65ca682e84cff77e36ad0d71862b33b4be5f9e:
iio: adc: palmas: Drop IRQF_EARLY_RESUME flag (2016-02-27 17:20:52 +0000)
----------------------------------------------------------------
Third set of IIO new device support, features and cleanups for the 4.6 cycle.
Good to see several new contributors in this set - and more generally a
number of new 'faces' over this whole cycle.
Staging movements
* hmc5843
- out of staging.
* periodic RTC trigger
- driver dropped. This is an ancient driver (brings back some memories ;)
that was always somewhat of a bodge. Originally there was a driver that
never went into mainline that supported large numbers of periodict timers
on the PXA270 via this route. Discussions to have a generic periodic
timer subsystem never went anywhere. At the time RTC periodic
interrupts were real - now they are emulated using high resolution
timers so with the HRT driver this has become pointless.
New device support
* mpu6050 driver
- Add support for the mpu6500.
* TI tpl0102 potentiometer
- new driver.
* Vybrid SoC DAC
- new driver. The ADC on this SoC has been supported for a while, this
adds a separate driver for the DAC.
New Features
* hmc5844
- Attributes to configure the bias current (typically part of a self test)
This could be done before via a somewhat obscure custom interface.
This at least makes it easy to tell what is going on.
- Document all custom attributes.
* mpu6050
- Add support for calibration offset control and readback.
* ms5611
- power regulator support. This is always one that gets added the
first time someone has a board that needs it. Here it was needed,
hence it was added.
Cleanups / minor fixes
* tree wide
- clean up all the myriad different return values in response to a
failure of i2c_check_functionality. After discussions everyone seemed
happy wiht -EOPNOTSUPP which seems to describe the situation well.
I encouraged a tree wide cleanup to set a good example in future for
this.
* core
- Typos in the iio_event_spec documentation in iio.h
* afe4403
- select REGMAP_SPI to avoid dependency issues
- mark suspend/resume as __maybe_unused to avoid warnings
* afe4404
- mark suspend/resume as __maybe_unused to avoid warnings
* atlas-ph-sensor
- switch the regmap cache type from linear to rbtree to gain reading of
registers on initial startup. It's not immediately obvious, but
regmap flat is meant for high performances cases so doesn't read these
registers.
- use regmap_bulk_read in one case where it was using
i2c_smbus_read_i2c_block_data directly (unlike everything else that was
through regmap).
* ina2xx
- stype cleanups (lots of them!)
* isl29018
- Get the struct device back from regmap rather than storing another
copy of it in the private data. This cleanup makes sense in a number
of other drivers so patches may well follow.
* mpu6050
- style cleanups (lots of them!)
- improved return value handling
- use usleep_range to avoid the usual issues with very short msleeps.
- add some missing documentation.
* ms5611
- use the probed device name for the device rather than the driver name.
- select IIO_BUFFER to avoid dependency issues
* palmas
- drop IRQF_EARLY_RESUME as no longer needed after genirq changes.
----------------------------------------------------------------
Alison Schofield (1):
staging: iio: isl29018: use regmap to retrieve struct device
Andrew F. Davis (2):
iio: ina2xx: Fix whitespace and re-order code
iio: ina2xx: Remove trace_printk debug statments
Arnd Bergmann (4):
iio: health/afe4403: select REGMAP_SPI
iio: health/afe4403: mark suspend/resume functions __maybe_unused
iio: health/afe4404: mark suspend/resume functions __maybe_unused
iio: pressure: ms5611: select IIO_BUFFER
Cristina Moraru (3):
iio: hmc5843: Add attributes for measurement config of bias current
iio: hmc5843: Add ABI documentation file for hmc5843
iio: hmc5843: Move hmc5843 out of staging
Daniel Baluta (7):
iio: imu: inv_mpu6050: Fix multiline comments style
iio: imu: inv_mpu6050: Fix Yoda conditions
iio: imu: inv_mpu6050: Fix newlines to make code easier to read
iio: imu: inv_mpu6050: Remove unnecessary parentheses
iio: imu: inv_mpu6050: Delete space before comma
iio: imu: inv_mpu6050: Fix code indent for if statement
iio: imu: inv_mpu6050: Fix alignment with open parenthesis
Gregor Boirie (1):
iio:pressure:ms5611: fix ms5607 temp compensation
Grygorii Strashko (1):
iio: adc: palmas: Drop IRQF_EARLY_RESUME flag
Grégor Boirie (2):
iio:pressure:ms5611: use probed device name
iio:pressure:ms5611: power regulator support
Lars-Peter Clausen (1):
staging:iio: Remove periodic RTC trigger driver
Matt Ranostay (10):
iio: chemical: atlas-ph-sensor: switch regmap cache
iio: chemical: atlas-ph-sensor: use regmap_bulk_read
iio: imu: mpu6050: remove trailing whitespaces
iio: potentiometer: add TI tpl0102 support
iio: imu: mpu6050: use inv_mpu6050_sensor_show return code
iio: imu: mpu6050: fix INV_MPU6050_REG_UP_TIME delay
iio: imu: mpu6050: add missing docstring for int_pin_cfg
iio: imu: mpu6050: add calibration offset support
iio: imu: mpu6050: add mpu6500 register settings
iio: convert to common i2c_check_functionality() return value
Sanchayan Maity (1):
iio: dac: vf610_dac: Add IIO DAC driver for Vybrid SoC
William Breathitt Gray (1):
iio: Fix typos in the struct iio_event_spec documentation comments
.../ABI/testing/sysfs-bus-iio-magnetometer-hmc5843 | 15 ++
Documentation/ABI/testing/sysfs-bus-iio-vf610 | 9 +
.../devicetree/bindings/iio/dac/vf610-dac.txt | 20 ++
drivers/iio/adc/ina2xx-adc.c | 155 +++++------
drivers/iio/adc/mcp3422.c | 2 +-
drivers/iio/adc/palmas_gpadc.c | 6 +-
drivers/iio/adc/ti-adc081c.c | 2 +-
drivers/iio/chemical/atlas-ph-sensor.c | 10 +-
drivers/iio/chemical/vz89x.c | 2 +-
drivers/iio/dac/Kconfig | 10 +
drivers/iio/dac/Makefile | 1 +
drivers/iio/dac/vf610_dac.c | 298 +++++++++++++++++++++
drivers/iio/health/Kconfig | 1 +
drivers/iio/health/afe4403.c | 4 +-
drivers/iio/health/afe4404.c | 4 +-
drivers/iio/humidity/hdc100x.c | 2 +-
drivers/iio/humidity/htu21.c | 2 +-
drivers/iio/humidity/si7005.c | 2 +-
drivers/iio/humidity/si7020.c | 2 +-
drivers/iio/imu/inv_mpu6050/inv_mpu_acpi.c | 6 +-
drivers/iio/imu/inv_mpu6050/inv_mpu_core.c | 197 ++++++++++----
drivers/iio/imu/inv_mpu6050/inv_mpu_i2c.c | 10 +-
drivers/iio/imu/inv_mpu6050/inv_mpu_iio.h | 20 +-
drivers/iio/imu/inv_mpu6050/inv_mpu_ring.c | 23 +-
drivers/iio/imu/inv_mpu6050/inv_mpu_spi.c | 3 +-
drivers/iio/imu/inv_mpu6050/inv_mpu_trigger.c | 22 +-
drivers/iio/light/bh1750.c | 2 +-
drivers/iio/light/jsa1212.c | 2 +-
drivers/iio/magnetometer/Kconfig | 33 +++
drivers/iio/magnetometer/Makefile | 4 +
drivers/{staging => }/iio/magnetometer/hmc5843.h | 0
.../{staging => }/iio/magnetometer/hmc5843_core.c | 140 ++++++----
.../{staging => }/iio/magnetometer/hmc5843_i2c.c | 0
.../{staging => }/iio/magnetometer/hmc5843_spi.c | 0
drivers/iio/potentiometer/Kconfig | 12 +
drivers/iio/potentiometer/Makefile | 1 +
drivers/iio/potentiometer/mcp4531.c | 2 +-
drivers/iio/potentiometer/tpl0102.c | 166 ++++++++++++
drivers/iio/pressure/Kconfig | 1 +
drivers/iio/pressure/mpl115_i2c.c | 2 +-
drivers/iio/pressure/ms5611.h | 3 +-
drivers/iio/pressure/ms5611_core.c | 30 ++-
drivers/iio/pressure/ms5611_i2c.c | 4 +-
drivers/iio/pressure/ms5611_spi.c | 4 +-
drivers/iio/pressure/ms5637.c | 2 +-
drivers/iio/pressure/t5403.c | 2 +-
drivers/iio/proximity/pulsedlight-lidar-lite-v2.c | 2 +-
drivers/iio/temperature/mlx90614.c | 2 +-
drivers/iio/temperature/tmp006.c | 2 +-
drivers/iio/temperature/tsys01.c | 2 +-
drivers/iio/temperature/tsys02d.c | 2 +-
drivers/staging/iio/Kconfig | 1 -
drivers/staging/iio/Makefile | 1 -
drivers/staging/iio/TODO | 8 -
drivers/staging/iio/light/isl29018.c | 28 +-
drivers/staging/iio/magnetometer/Kconfig | 40 ---
drivers/staging/iio/magnetometer/Makefile | 7 -
drivers/staging/iio/trigger/Kconfig | 10 -
drivers/staging/iio/trigger/Makefile | 1 -
.../staging/iio/trigger/iio-trig-periodic-rtc.c | 216 ---------------
include/linux/iio/iio.h | 6 +-
61 files changed, 1000 insertions(+), 566 deletions(-)
create mode 100644 Documentation/ABI/testing/sysfs-bus-iio-magnetometer-hmc5843
create mode 100644 Documentation/devicetree/bindings/iio/dac/vf610-dac.txt
create mode 100644 drivers/iio/dac/vf610_dac.c
rename drivers/{staging => }/iio/magnetometer/hmc5843.h (100%)
rename drivers/{staging => }/iio/magnetometer/hmc5843_core.c (86%)
rename drivers/{staging => }/iio/magnetometer/hmc5843_i2c.c (100%)
rename drivers/{staging => }/iio/magnetometer/hmc5843_spi.c (100%)
create mode 100644 drivers/iio/potentiometer/tpl0102.c
delete mode 100644 drivers/staging/iio/magnetometer/Kconfig
delete mode 100644 drivers/staging/iio/magnetometer/Makefile
delete mode 100644 drivers/staging/iio/trigger/iio-trig-periodic-rtc.c
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2016-02-28 17:06 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2016-02-28 17:06 [PULL] Third set of IIO new device support, features and cleanups for the 4.6 cycle Jonathan Cameron
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).