Re: [PATCH v9 1/4] iio: pressure: bmp280: Use sleep and forced mode for oneshot captures

[ASSI <Stromeko@nexgo.de>]

David Lechner writes:
> Hopefully you can compile your own kernel and test this. If that fixes it
> we can turn it into a proper patch.

I've out-of-tree re-compiled the module with the patch applied, booted
into the kernel with secure boot / validation switched off, removed the
compiled-in module and did an insmod for the patched one.  It works and
I can read all values again most of the time at oversampling=1 and
consistently at oversampling=2 for all channels.

I'll try my suggestion of a tapered wait later, perhaps over the
weekend, now that I don't need to reboot to play around with the module
code.

Setting oversampling=1 on all three channels gets me a fuil acquisition
at ~33ms now (was ~28ms with the too short wait time), oversampling=2 is
at ~64ms.  I'll need to figure out how to enable and use the triggered
buffer to get that back to more reasonable times.


Regards,
Achim.
-- 
+<[Q+ Matrix-12 WAVE#46+305 Neuron microQkb Andromeda XTk Blofeld]>+