messages from 2018-10-31 14:20:05 to 2018-11-09 23:19:52 UTC [more...]
[PATCH 0/6] staging:iio:ad2s90: Add dt support and move out of staging
2018-11-09 23:19 UTC (7+ messages)
` [PATCH 1/6] staging:iio:ad2s90: Add device tree support
` [PATCH 2/6] staging:iio:ad2s90: Remove spi setup that should be done via dt
` [PATCH 3/6] staging:iio:ad2s90: Add max frequency check at probe
` [PATCH 5/6] staging:iio:ad2s90: Add SPDX license identifier
Questions related to some drivers
2018-11-09 22:08 UTC (11+ messages)
[PATCH][RFC] iio: Move attach/detach of the poll func to the core
2018-11-09 11:10 UTC (5+ messages)
[PATCH v3 0/4] staging: iio: ad7816: Switch to the gpio descriptor interface
2018-11-09 8:11 UTC (8+ messages)
` [PATCH v3 1/4] "
` [PATCH v3 2/4] staging: iio: ad7816: Do not use busy_pin in case of AD7818
` [PATCH v3 3/4] staging: iio: ad7816: Set RD/WR pin and CONVST pin as outputs
` [PATCH v3 4/4] staging: iio: ad7816: Add device tree table
[PATCH v5 1/1] staging: iio: adc: ad7280a: use devm_* APIs
2018-11-09 16:59 UTC (5+ messages)
[PATCH v4 4/4] dt-bindings: iio: adc: Add docs for ad7124
2018-11-09 15:43 UTC
[PATCH v4 3/4] iio: adc: Add ad7124 support
2018-11-09 15:41 UTC
[PATCH] iio: adc: sc27xx: Add ADC data conversion timeout
2018-11-09 3:25 UTC
[PATCH] IIO: extend dac/MCP4922 to MCP49x1 devices
2018-11-08 20:36 UTC
[PATCH v3 2/3] iio: adc: Add ad7124 support
2018-11-08 16:48 UTC (5+ messages)
[PATCH v2 0/2] pattern generation and gain update
2018-11-08 18:26 UTC (6+ messages)
` [PATCH v2 1/2] staging: iio: ad7780: check if ad778x before "
` [PATCH v2 2/2] staging: iio: ad7780: generates pattern_mask from PAT bits
[PATCH 0/3] staging: iio: ad7780: pattern generation and gain update
2018-11-08 7:45 UTC (7+ messages)
` [PATCH 1/3] staging: iio: ad7780: Add is_ad778x flag chip info
` [PATCH 2/3] staging: iio: ad7780: check if ad778x before gain update
` [PATCH 3/3] staging: iio: ad7780: generates pattern_mask from PAT bits
[PATCH] iio: adc: max9611: convert to SPDX identifiers
2018-11-08 6:42 UTC
[PATCH] iio: adc: max11100: convert to SPDX identifiers
2018-11-08 6:41 UTC
[PATCH v6 0/3] Add support for PNI RM3100 magnetometer
2018-11-08 9:27 UTC (4+ messages)
` [PATCH v6 1/3] dt-bindings: Add PNI to the vendor prefixes
` [PATCH v6 2/3] iio: magnetometer: Add DT support for PNI RM3100
` [PATCH v6 3/3] iio: magnetometer: Add driver "
Question about max frequency in ad2s90
2018-11-08 7:23 UTC (6+ messages)
[PATCH] iio: adc: rcar-gyroadc: convert to SPDX identifiers
2018-11-08 6:40 UTC
[PATCH v7 1/2] iio: light: Add support for vishay vcnl4035
2018-11-07 20:24 UTC (3+ messages)
` [PATCH v7 2/2] iio: light: Add device tree binding "
[PATCH] iio: st-accel: add support for lis3de
2018-11-07 15:45 UTC
Work plan on ad5933
2018-11-07 13:39 UTC (2+ messages)
[PATCH v2] staging: iio: adc: ad7280a: do not pass the copy of struct element
2018-11-07 22:39 UTC (3+ messages)
[PATCH] iio: potentiometer: Add driver for Microchip MCP41xxx/42xxx
2018-11-07 9:48 UTC (8+ messages)
[PATCH 0/2] iio: pressure: Add support for Honeywell HSC SPI sensors
2018-11-06 21:29 UTC (6+ messages)
` [PATCH 1/2] dt-bindings: "
[PATCH] staging: iio: adc: ad7280a: do not pass the copy of struct element
2018-11-06 18:48 UTC
[PATCH 1/3] iio: adc: add STMPE ADC driver using IIO framework
2018-11-06 16:41 UTC (3+ messages)
` [PATCH 2/3] iio: adc: add STMPE ADC devicetree bindings
` [PATCH 3/3] ARM: dts: Add stmpe-adc driver to relevant devicetrees
[PATCH v4 0/2] staging: iio: ad7780: correct driver read
2018-11-06 9:25 UTC (5+ messages)
` [PATCH v4 1/2] staging: iio: ad7780: update voltage on read
` [PATCH v4 2/2] staging: iio: ad7780: remove unnecessary stashed voltage value
[PATCH v2 0/2] meson-saradc: add chip temperature support
2018-11-05 22:16 UTC (7+ messages)
` [PATCH v2 1/2] dt-bindings: iio: adc: meson-saradc: add temperature sensor support
` [PATCH v2 2/2] iio: adc: meson-saradc: add support for the chip's temperature sensor
[PATCH v5 0/3] Add support for PNI RM3100 magnetometer
2018-11-05 19:26 UTC (7+ messages)
` [PATCH v5 1/3] dt-bindings: Add PNI to the vendor prefixes
` [PATCH v5 2/3] iio: magnetometer: Add DT support for PNI RM3100
` [PATCH v5 3/3] iio: magnetometer: Add driver "
[PATCH v5 00/11] AXP8x3 AC and battery power supply support
2018-11-05 5:47 UTC (8+ messages)
` [PATCH v5 04/11] dt-bindings: iio: adc: add AXP803 ADC bindings
[PATCH v3 0/3] Add support for PNI RM3100 magnetometer
2018-11-05 0:39 UTC (9+ messages)
` [PATCH v4 "
` [PATCH v4 3/3] iio: magnetometer: Add driver support for PNI RM3100
[PATCH 0/7] add i2c controller support to st_lsm6dsx driver
2018-11-04 19:07 UTC (26+ messages)
` [PATCH 1/7] iio: imu: st_lsm6dsx: introduce locked read/write utility routines
` [PATCH 2/7] iio: imu: st_lsm6dsx: reboot memory content after reset
` [PATCH 3/7] iio: imu: st_lsm6dsx: remove static from st_lsm6dsx_set_watermark
` [PATCH 4/7] iio: imu: st_lsm6dsx: introduce ST_LSM6DSX_ID_EXT sensor ids
` [PATCH 5/7] iio: imu: st_lsm6dsx: add i2c embedded controller support
` [PATCH 6/7] iio: imu: st_lsm6dsx: add hw FIFO support to i2c controller
` [PATCH 7/7] dt-bindings: iio: imu: st_lsm6dsx: add support to i2c pullup resistors
Work plan on ad2s90
2018-11-04 18:27 UTC (6+ messages)
[PATCH v3 0/6] staging:iio:ad2s90: Add scale info and improve error handling
2018-11-04 16:51 UTC (13+ messages)
` [PATCH v3 1/6] staging:iio:ad2s90: Make read_raw return spi_read's error code
` [PATCH v3 2/6] staging:iio:ad2s90: Make probe handle spi_setup failure
` [PATCH v3 3/6] staging:iio:ad2s90: Remove always overwritten assignment
` [PATCH v3 4/6] staging:iio:ad2s90: Move device registration to the end of probe
` [PATCH v3 5/6] staging:iio:ad2s90: Add IIO_CHAN_INFO_SCALE to channel spec and read_raw
` [PATCH v3 6/6] staging:iio:ad2s90: Check channel type at read_raw
[PATCH v4 1/1] staging: iio: adc: ad7280a: use devm_* APIs
2018-11-04 10:48 UTC (3+ messages)
[PATCH v2 0/6] staging:iio:ad2s90: Add scale info and improve error handling
2018-11-03 17:26 UTC (13+ messages)
` [PATCH v2 1/6] staging:iio:ad2s90: Make read_raw return spi_read's error code
` [PATCH v2 2/6] staging:iio:ad2s90: Make probe handle spi_setup failure
` [PATCH v2 5/6] staging:iio:ad2s90: Add IIO_CHAN_INFO_SCALE to channel spec and read_raw
[PATCH v3 0/3] staging: iio: ad7780: correct driver read
2018-11-03 17:23 UTC (14+ messages)
` [PATCH v3 1/3] staging: iio: ad7780: fix offset read value
` [PATCH v3 2/3] staging: iio: ad7780: update voltage on read
` [PATCH v3 3/3] staging: iio: ad7780: remove unnecessary stashed voltage value
[PATCH] iio: sx932x: Add driver for Semtech sx932x proximity sensor
2018-11-03 16:59 UTC (2+ messages)
[PATCH v7 0/3] staging: iio: ad2s1210: Switch to the gpio descriptor interface
2018-11-03 13:07 UTC (10+ messages)
` [PATCH v7 1/3] "
` [PATCH v7 2/3] staging: iio: ad2s1210: Drop the gpioin flag
` [PATCH v7 3/3] staging: iio: ad2s1210: Add device tree table
[PATCH v2] iio/hid-sensors: Fix IIO_CHAN_INFO_RAW returning wrong values for signed numbers
2018-11-03 15:53 UTC (4+ messages)
[PATCH v4 1/2] iio:dac:ti-dac7311 Add driver for Texas Instrument DAC7311
2018-11-03 12:12 UTC (3+ messages)
[PATCH v3 3/3] dt-bindings: iio: adc: Add docs for ad7124
2018-11-03 11:58 UTC (3+ messages)
[PATCH v3 0/3] Add Xilinx AMS Driver
2018-11-03 11:50 UTC (3+ messages)
` [PATCH v3 2/3] iio: adc: Add Xilinx AMS driver
[PATCH] iio:st_magn: enable device after trigger
2018-11-03 11:25 UTC (2+ messages)
[PATCH v2 1/4] iio: magnetometer: add clarifying comment
2018-11-03 10:30 UTC (5+ messages)
` [PATCH v2 4/4] dt-bindings: iio: magn: add LSM9DS1 bindings
[PATCH] iio:st_magn: enable trigger before enabling sensor
2018-11-03 10:26 UTC (6+ messages)
[PATCH v3 1/1] staging: iio: adc: ad7280a: use devm_* APIs
2018-11-03 10:18 UTC (6+ messages)
[PATCH v2 1/2] iio:temperature: Add MAX31856 thermocouple support
2018-11-02 9:33 UTC (4+ messages)
[PATCH v5 0/2] arm64: dts: qcom: pm8998: Add die temperature channel node to the ADC
2018-11-02 9:28 UTC (8+ messages)
` [PATCH v5 1/2] dt-bindings: iio: vadc: Update example to include unit address for node 'usb-id-nopull'
[PATCH] media: uvcvideo: Add boottime clock support
2018-11-01 15:03 UTC (5+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox