Re: [PATCH v3 08/10] iio: adc: ad4170: Add GPIO controller support

[Bartosz Golaszewski <brgl@bgdev.pl>]

On Tue, May 13, 2025 at 2:36 PM Marcelo Schmitt
<marcelo.schmitt@analog.com> wrote:
>
> The AD4170 has four multifunctional pins that can be used as GPIOs. The
> GPIO functionality can be accessed when the AD4170 chip is not busy
> performing continuous data capture or handling any other register
> read/write request. Also, the AD4170 does not provide any interrupt based
> on GPIO pin states so AD4170 GPIOs can't be used as interrupt sources.
>
> Implement gpio_chip callbacks to make AD4170 GPIO pins controllable through
> the gpiochip interface.
>
> Signed-off-by: Marcelo Schmitt <marcelo.schmitt@analog.com>
> ---
> Change log v2 -> v3
> - Defined masks for updating GPIO mode register.
> - Replaced regmap_clear/set_bits() by regmap_update_bits() to set GPIO direction.
> - Removed GPIO direction check before setting GPIO output values.
> - Made use of regmap_assign_bits() to set GPIO output reg bits.
> - Made value to be set as GPIO output state be either 0 or 1.
> - No longer locking on state mutex on GPIO set since GPIO output should not
>   conflict with other direct mode functionality (e.g. single-shot read).
>
>  drivers/iio/adc/Kconfig  |   1 +
>  drivers/iio/adc/ad4170.c | 224 ++++++++++++++++++++++++++++++++++++++-
>  2 files changed, 224 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/iio/adc/Kconfig b/drivers/iio/adc/Kconfig
> index 6e4b14243599..a328f03eea34 100644
> --- a/drivers/iio/adc/Kconfig
> +++ b/drivers/iio/adc/Kconfig
> @@ -78,6 +78,7 @@ config AD4170
>         select IIO_BUFFER
>         select IIO_TRIGGERED_BUFFER
>         depends on COMMON_CLK
> +       select GPIOLIB

In general GPIOLIB should be depended on, not selected.

The rest looks good to me so with that:

Acked-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>