Re: [bug report] iio: dac: adding support for Microchip MCP47FEB02

[Dan Carpenter <dan.carpenter@linaro.org>]

On Fri, Feb 06, 2026 at 04:04:07PM +0200, Andy Shevchenko wrote:
> > drivers/iio/dac/mcp47feb02.c
> >     712 static int mcp47feb02_init_scales_avail(struct mcp47feb02_data *data, int vdd_mV,
> >     713                                         int vref_mV, int vref1_mV)
> >     714 {
> >     715         struct device *dev = regmap_get_device(data->regmap);
> >     716         int tmp_vref;
> >     717 
> >     718         mcp47feb02_init_scale(data, MCP47FEB02_SCALE_VDD, vdd_mV, data->scale);
> >     719 
> >     720         if (data->use_vref)
> >     721                 tmp_vref = vref_mV;
> >     722         else
> >     723                 tmp_vref = MCP47FEB02_INTERNAL_BAND_GAP_mV;
> >     724 
> >     725         mcp47feb02_init_scale(data, MCP47FEB02_SCALE_GAIN_X1, tmp_vref, data->scale);
> >     726         mcp47feb02_init_scale(data, MCP47FEB02_SCALE_GAIN_X2, tmp_vref * 2, data->scale);
> >     727 
> >     728         if (data->phys_channels >= 4) {
> >     729                 mcp47feb02_init_scale(data, MCP47FEB02_SCALE_VDD, vdd_mV, data->scale_1);
> >     730 
> >     731                 if (data->use_vref1 && vref1_mV <= 0)
> > --> 732                         return dev_err_probe(dev, vref1_mV, "Invalid voltage for Vref1\n");
> >                                                           ^^^^^^^^
> > vref1_mV is not a valid error code.
> 
> Why not? When it's negative I believe the above statement is not true.
> 

I saw this as just sanity checking the input.  vref1_mV is never
actually negative.  I don't know if devm_regulator_get_enable_read_voltage()
can return less than one millivolt.

regards,
dan carpenter