Re: [PATCH RESEND v3 3/5] iio: adc: qcom-spmi-adc5: Fall back to datasheet_name instead of fwnode name

[Dmitry Baryshkov <dmitry.baryshkov@linaro.org>]

On 02/05/2023 02:17, Marijn Suijten wrote:
> Since the migration to fwnode_get_name in commit 4f47a236a23d ("iio:
> adc: qcom-spmi-adc5: convert to device properties") the resulting
> adc5_channel_prop::channel_name (renamed from datasheet_name in the
> previous patch) - which is propagated into iio_chan_spec::extend_name -
> was containing the DT node name including @xx suffix if a "label"
> property is not present, while adc5_channels::datasheet_name was thus
> far set by the macros but always remained unread.  Put it to use instead
> of using a confusing name containing @xx in sysfs filenames (again, when
> "label" is not set).
> 
> Signed-off-by: Marijn Suijten <marijn.suijten@somainline.org>
> ---
>   drivers/iio/adc/qcom-spmi-adc5.c | 2 +-
>   1 file changed, 1 insertion(+), 1 deletion(-)

Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>

-- 
With best wishes
Dmitry