Re: [PATCH 2/5] qt602240_ts: move clearing of pending interrupt closer to request_threaded_irq

[Dmitry Torokhov <dmitry.torokhov@gmail.com>]

On Thu, Nov 18, 2010 at 11:29:02AM -0800, Chris Leech wrote:
> On Thu, Nov 18, 2010 at 09:53:13PM +0900, Joonyoung Shim wrote:
> > Hi, Chris.
> >
> > On 2010-11-17 오전 5:41, Chris Leech wrote:
> >> I've seen interrupts asserted on the CHG pin between the call to make_highcgh()
> >> during initialization and registering the interrupt handler, leaving CHG low
> >> and no events get passed up.
> >>
> >
> > The CHG pin can be affected by control of gpios connected to touch
> > chip. Could you check it? I think it doesn't matter where
> > make_highchg() exists actually.
> 
> My understanding is that CHG is to be used to trigger interrupts, and
> the attached gpio should be set as an input.  I'm not sure trying to set
> the value from the gpio side is going to work.
> 
> The problem I was seeing was the attached gpio configured as a
> falling-edge-triggered interrupt stuck in the low state, and
> qt602240_interrupt is never called.  What that says to me is that CHG
> transitioned low before the interrupt handler was registered.  From what
> I can see, the only way to reset CHG is to clear the queue of pending
> messages, which is what make_highchg does.
> 

I wonder if it should actually go into qt602240_start().

-- 
Dmitry
--
To unsubscribe from this list: send the line "unsubscribe linux-input" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html