Re: [PATCH 1/3] mfd: stmpe: add pull up/down register offsets for STMPE

[Dmitry Torokhov <dmitry.torokhov@gmail.com>]

On Thu, Dec 04, 2014 at 07:10:30PM +0100, Linus Walleij wrote:
> On Mon, Nov 3, 2014 at 1:25 PM, Lee Jones <lee.jones@linaro.org> wrote:
> > On Fri, 24 Oct 2014, Dmitry Torokhov wrote:
> >
> >> On Mon, Oct 20, 2014 at 07:46:05AM +0100, Lee Jones wrote:
> >> > On Sat, 18 Oct 2014, Linus Walleij wrote:
> >> >
> >> > > This adds the register offsets for pull up/down for the STMPE
> >> > > 1601, 1801 and 24xx expanders. This is used to bias GPIO lines
> >> > > and keypad lines.
> >> > >
> >> > > Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
> >> > > ---
> >> > > Hi Sam, Lee: I think you should just ACK this so Dmitry can take the
> >> > > patch series through the input tree, where the registers need to be
> >> > > used to enable the keypad on the STMPE2401.
> >> > > ---
> >> > >  drivers/mfd/stmpe.c       | 4 ++++
> >> > >  drivers/mfd/stmpe.h       | 3 +++
> >> > >  include/linux/mfd/stmpe.h | 2 ++
> >> > >  3 files changed, 9 insertions(+)
> >> >
> >> > Does this need to go in with the other patches in the set?
> >> >
> >> > I'm _guessing_ that, as you've sent them separately, they can be
> >> > applied separately?
> >> >
> >> > This needs to go in via MFD, but for my own reference:
> >> >
> >> > Acked-by: Lee Jones <lee.jones@linaro.org>
> >>
> >> The new register definitions are needed for patch #3.  If you insist on
> >> this going through MFD then please take the other 2 patches with my Ack
> >> through MFD tree as well I do not think we need the whole song and dance
> >> trying to synchronize 2 trees.
> >
> > Actually, I can't see the other patches as they weren't sent to me.
> >
> > Please apply them all to your tree with my Ack.
> 
> Dmitry can you please apply them so we don't miss this merge window...

I had a question about missing error handling in 3/3? Have you seen it?

-- 
Dmitry