From mboxrd@z Thu Jan 1 00:00:00 1970 From: Dmitry Torokhov Subject: Re: [PATCH] Input: cyapa_gen3: use msleep() for long delay Date: Sun, 15 Jan 2017 15:20:10 -0800 Message-ID: <20170115232010.GE23285@dtor-ws> References: <1484478787-13178-1-git-send-email-hofrat@osadl.org> Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii Return-path: Received: from mail-pg0-f67.google.com ([74.125.83.67]:33923 "EHLO mail-pg0-f67.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1751087AbdAOXUN (ORCPT ); Sun, 15 Jan 2017 18:20:13 -0500 Content-Disposition: inline In-Reply-To: <1484478787-13178-1-git-send-email-hofrat@osadl.org> Sender: linux-input-owner@vger.kernel.org List-Id: linux-input@vger.kernel.org To: Nicholas Mc Guire Cc: Henrik Rydberg , Dudley Du , linux-input@vger.kernel.org, linux-kernel@vger.kernel.org On Sun, Jan 15, 2017 at 12:13:07PM +0100, Nicholas Mc Guire wrote: > ulseep_range() uses hrtimers and provides no advantage over msleep() > for larger delays. Fix up the 50ms delays here to use msleep() and > reduce the load on the hrtimer subsystem. > > Signed-off-by: Nicholas Mc Guire Applied, thank you. > --- > Problem found by coccinelle script > > As the needed delay is specified in the comment as being "at least 50ms" > the msleep(50) should be fine here. > > Note that cyapa_gen3_bl_exit() is returning -EAGAIN in cases where it was > not yet ready to process the request, but the calling side > cyapa_gen3_do_operational_check() does not check for -EAGAIN so in case of > the noted increased delay "...can take up to an additional 2 seconds. If > the device power is running low, this may take even longer", maybe > cyapa_gen3_do_operational_check() may need a retry loop on -EAGAIN ? > > Patch was compile tested with: x86_64_defconfig + CONFIG_MOUSE_CYAPA=m > > Patch is against 4.10-rc3 (localversion-next is next-20170113) > > drivers/input/mouse/cyapa_gen3.c | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/drivers/input/mouse/cyapa_gen3.c b/drivers/input/mouse/cyapa_gen3.c > index f9600753..6e9ecb0 100644 > --- a/drivers/input/mouse/cyapa_gen3.c > +++ b/drivers/input/mouse/cyapa_gen3.c > @@ -562,7 +562,7 @@ static int cyapa_gen3_bl_exit(struct cyapa *cyapa) > * Wait for bootloader to exit, and operation mode to start. > * Normally, this takes at least 50 ms. > */ > - usleep_range(50000, 100000); > + msleep(50); > /* > * In addition, when a device boots for the first time after being > * updated to new firmware, it must first calibrate its sensors, which > -- > 2.1.4 > -- Dmitry