Re: [PATCH 2/5] Input: auo-pixcir-ts - switch to using gpiod API

[Heiko Stuebner <heiko@sntech.de>]

Am Mittwoch, 14. September 2022, 16:14:25 CEST schrieb Dmitry Torokhov:
> This switches the driver to gpiod API and drops uses of of_get_gpio() API.
> 
> Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
> ---
>  drivers/input/touchscreen/auo-pixcir-ts.c | 47 ++++++++++-------------
>  1 file changed, 20 insertions(+), 27 deletions(-)

[...]

> @@ -578,23 +566,28 @@ static int auo_pixcir_probe(struct i2c_client *client,
>  
>  	input_set_drvdata(ts->input, ts);
>  
> -	error = devm_gpio_request_one(&client->dev, ts->gpio_int,
> -				      GPIOF_DIR_IN, "auo_pixcir_ts_int");
> +	ts->gpio_int = devm_gpiod_get_index(&client->dev, NULL, 0, GPIOD_IN);
> +	error = PTR_ERR_OR_ZERO(ts->gpio_int);
>  	if (error) {
> -		dev_err(&client->dev, "request of gpio %d failed, %d\n",
> -			ts->gpio_int, error);
> +		dev_err(&client->dev,
> +			"request of int gpio failed: %d\n", error);
>  		return error;
>  	}
>  
> -	error = devm_gpio_request_one(&client->dev, ts->gpio_rst,
> -				      GPIOF_DIR_OUT | GPIOF_INIT_HIGH,
> -				      "auo_pixcir_ts_rst");
> +	gpiod_set_consumer_name(ts->gpio_int, "auo_pixcir_ts_int");
> +
> +	/* Take the chip out of reset */
> +	ts->gpio_rst = devm_gpiod_get_index(&client->dev, NULL, 1,
> +					    GPIOD_OUT_LOW);

hmm, is this really equivalent? It looks like above we're startig
with GPIOF_INIT_HIGH, while here it is LOW?

Looking at the old datasheet, yes gpio-high is the setting to
put the device into the usable state.

Interestingly there is no regulator support in the driver, the datahsheet
specifies 0.5ms for rst-low to rst-high after vdd_tp is turned on.

Heiko

Heiko