Re: [RFC PATCH 1/4] dt-bindings: input: Add support for the MPR121 without interrupt line

["Michal Vokáč" <michal.vokac@ysoft.com>]

On 02. 05. 19 2:48, Rob Herring wrote:
> On Fri, Apr 26, 2019 at 10:30:17AM +0200, Michal Vokáč wrote:
>> Normally, the MPR121 controller uses separate interrupt line to notify
>> the I2C host that a key was touched/released. To support platforms that
>> can not use the interrupt line, polling of the MPR121 registers can be
>> used.
> 
> Other than making the 'interrupts' property optional, that's a driver
> change, not a DT change. IOW, we shouldn't need a whole new binding.
> 

OK, I will update the existing binding instead.

Thank you,
Michal

>>
>> Signed-off-by: Michal Vokáč <michal.vokac@ysoft.com>
>> ---
>>   .../bindings/input/mpr121-touchkey-polled.txt      | 26 ++++++++++++++++++++++
>>   1 file changed, 26 insertions(+)
>>   create mode 100644 Documentation/devicetree/bindings/input/mpr121-touchkey-polled.txt
>>
>> diff --git a/Documentation/devicetree/bindings/input/mpr121-touchkey-polled.txt b/Documentation/devicetree/bindings/input/mpr121-touchkey-polled.txt
>> new file mode 100644
>> index 000000000000..6bb1d312614c
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/input/mpr121-touchkey-polled.txt
>> @@ -0,0 +1,26 @@
>> +* Freescale MPR121 Controller without interrupt line
>> +
>> +Required Properties:
>> +- compatible:		Should be "fsl,mpr121-touchkey-polled"
>> +- reg:			The I2C slave address of the device.
>> +- vdd-supply:		Phandle to the Vdd power supply.
>> +- linux,keycodes:	Specifies an array of numeric keycode values to
>> +			be used for reporting button presses. The array can
>> +			contain up to 12 entries.
>> +
>> +Optional Properties:
>> +- autorepeat:		Enable autorepeat feature.
>> +
>> +Example:
>> +
>> +#include "dt-bindings/input/input.h"
>> +
>> +	touchkeys: keys@5a {
>> +		compatible = "fsl,mpr121-touchkey-polled";
>> +		reg = <0x5a>;
>> +		autorepeat;
>> +		vdd-supply = <&ldo4_reg>;
>> +		linux,keycodes = <KEY_0>, <KEY_1>, <KEY_2>, <KEY_3>,
>> +				<KEY_4> <KEY_5>, <KEY_6>, <KEY_7>,
>> +				<KEY_8>, <KEY_9>, <KEY_A>, <KEY_B>;
>> +	};
>> -- 
>> 2.1.4
>>