Re: [PATCH v2 2/2] ARM: shmobile: Armadillo800EVA: Move st1232 reset pin handling

[Bastian Hecht <hechtb@gmail.com>]

2013/4/9 Simon Horman <horms@verge.net.au>:
> On Tue, Apr 09, 2013 at 11:16:18AM +0200, Bastian Hecht wrote:
>> 2013/4/9 Simon Horman <horms@verge.net.au>:
>> > On Tue, Apr 09, 2013 at 05:26:44PM +0900, Simon Horman wrote:
>> >> On Mon, Apr 08, 2013 at 04:17:22PM +0200, Laurent Pinchart wrote:
>> >> > Hi Bastian,
>> >> >
>> >> > Thanks for the patch.
>> >> >
>> >> > On Monday 08 April 2013 14:52:27 Bastian Hecht wrote:
>> >> > > We no longer need to set up the reset pin for the st1232 in the board
>> >> > > code, but can pass the GPIO number via the platform data to the driver.
>> >> > > This results in a cleaner grouping of the device setup.
>> >> > >
>> >> > > Signed-off-by: Bastian Hecht <hechtb+renesas@gmail.com>
>> >> >
>> >> > Acked-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
>> >>
>> >> Thanks.
>> >>
>> >> I have queued this up in the boards-armadillo800eva branch.
>> >>
>> >> There were some conflicts when I applied the code which
>> >> I fixed manually. Bastian, can you please check that the
>> >> following is correct? If it is not please send an incremental patch.
>> >
>> > I was trying to apply your patch to an old branch.
>> > It applies cleanly to the correct new branch :)
>>
>> Ah sweet, I was indeed a bit confused about going back to the INTC as
>> primary controller.
>
> After all that I had to drop the patch as it depends on patch 1/2.
> Lets sort out which tree that patch is going through.
> I have sent an email to try and sort that out.

Thanks Simon!