Re: [PATCH][next] Input: qt1050: fix less than zero comparison on an unsigned int

[Colin Ian King <colin.king@canonical.com>]

On 07/05/2019 09:32, Marco Felsch wrote:
> Hi Ian,
> 
> On 19-05-07 09:21, Colin King wrote:
>> From: Colin Ian King <colin.king@canonical.com>
>>
>> Currently the less than zero comparison of val is always false because
>> val is an unsigned int. Fix this by making val a signed int.
> 
> Thanks for covering that, was an copy 'n' paste failure..
>>
>> Addresses-Coverity: ("Unsigned compared against zero")
>> Fixes: a33ff45923c8 ("Input: qt1050 - add Microchip AT42QT1050 support")
>> Signed-off-by: Colin Ian King <colin.king@canonical.com>
>> ---
>>  drivers/input/keyboard/qt1050.c | 2 +-
>>  1 file changed, 1 insertion(+), 1 deletion(-)
>>
>> diff --git a/drivers/input/keyboard/qt1050.c b/drivers/input/keyboard/qt1050.c
>> index 6b1603cb7515..4debddb13972 100644
>> --- a/drivers/input/keyboard/qt1050.c
>> +++ b/drivers/input/keyboard/qt1050.c
>> @@ -222,7 +222,7 @@ static struct regmap_config qt1050_regmap_config = {
>>  
>>  static bool qt1050_identify(struct qt1050_priv *ts)
>>  {
>> -	unsigned int val;
>> +	int val;
> 
> I think the proper solution is to add a ret val, because this covers the
> success/fail. I will send a patch to fix this.

OK, thanks for the follow-up fix.

Regards,
Colin

> 
> Regards,
>   Marco
> 
>>  	/* Read Chip ID */
>>  	regmap_read(ts->regmap, QT1050_CHIP_ID, &val);
>> -- 
>> 2.20.1
>>
>>
>