[RFC PATCH 08/21] iommu/amd: Allow nested IOMMU page tables

[Suravee Suthikulpanit <suravee.suthikulpanit@amd.com>]

The GCR3 table contains guest CR3 registers, and it is used to
setup guest page tables. Current logic only allow guest CR3 table
setup only when the host table is not setup (i.e. PAGE_MODE_NONE).
Therefore, only 1-level page translation is allowed
(e.g. host only vs. guest only).

Remove this restriction to allow nested page table setup.

Signed-off-by: Suravee Suthikulpanit <suravee.suthikulpanit@amd.com>
---
 drivers/iommu/amd/iommu.c | 11 ++++-------
 1 file changed, 4 insertions(+), 7 deletions(-)

diff --git a/drivers/iommu/amd/iommu.c b/drivers/iommu/amd/iommu.c
index 333c8a4831be..c23f99ebdffc 100644
--- a/drivers/iommu/amd/iommu.c
+++ b/drivers/iommu/amd/iommu.c
@@ -2531,12 +2531,12 @@ int amd_iommu_domain_enable_v2(struct iommu_domain *dom, int pasids, bool giov)
 	spin_lock_irqsave(&pdom->lock, flags);
 
 	/*
-	 * Save us all sanity checks whether devices already in the
-	 * domain support IOMMUv2. Just force that the domain has no
-	 * devices attached when it is switched into IOMMUv2 mode.
+	 * With nested page table, we can enable * v2 (i.e GCR3)
+	 * on a existing domain. Therefore, only check if domain
+	 * already enable v2.
 	 */
 	ret = -EBUSY;
-	if (pdom->dev_cnt > 0 || pdom->flags & PD_IOMMUV2_MASK)
+	if (pdom->flags & PD_IOMMUV2_MASK)
 		goto out;
 
 	if (!pdom->gcr3_tbl)
@@ -2688,9 +2688,6 @@ static int __set_gcr3(struct protection_domain *domain, u32 pasid,
 {
 	u64 *pte;
 
-	if (domain->iop.mode != PAGE_MODE_NONE)
-		return -EINVAL;
-
 	pte = __get_gcr3_pte(domain->gcr3_tbl, domain->glx, pasid, true);
 	if (pte == NULL)
 		return -ENOMEM;
-- 
2.34.1