Re: [PATCH v3 00/19] Exynos SYSMMU (IOMMU) integration with DT and DMA-mapping subsystem

[Joonyoung Shim <jy0922.shim@samsung.com>]

Hi,

On 01/14/2015 09:24 AM, Javier Martinez Canillas wrote:
> On 01/14/2015 01:19 AM, Javier Martinez Canillas wrote:
>>
>> I dug further on this issue and found that the cause is that the exynos_mixer
>> driver needs some clocks (CLK_HDMI and CLK_SCLK_HDMI) grabbed by exynos_hdmi
>> to be kept enabled after hdmi_poweroff (drivers/gpu/drm/exynos/exynos_hdmi.c).
>>
>> Otherwise, any access to mixer device registers leads to an imprecise external
>> abort error. The following change [0] to the Exynos DRM HDMI driver makes the
>> issue to not happen and I can successfully execute:
>>
>> # echo 1 > /sys/devices/platform/exynos-drm/graphics/fb0/blank
>> # echo 0 > /sys/devices/platform/exynos-drm/graphics/fb0/blank
>>

Did you execute this operation repeatedly? Still i get error when i
execute this more than twice with your change [0].

Thanks.

>> Only not disabling the hdmi clock [1]: is enough but doing so makes sometimes the
>> DISP1 power domain disabling fails. It doesn't seem to have side effect though
>> since I also see the signal in the HDMI display to go standby and then on again.
>>
>> # echo 0 > /sys/devices/platform/exynos-drm/graphics/fb0/blank
>> # echo 1 > /sys/devices/platform/exynos-drm/graphics/fb0/blank
>> [   63.089080] Power domain disp1-power-domain disable failed
>> # echo 0 > /sys/devices/platform/exynos-drm/graphics/fb0/blank
>> #
>>
>> That error message when both clocks are not disabled on hdmi_poweroff() though.
>>
> 
> This should be: "That error message is not shown when both clocks are disabled".
> 
> Best regards,
> Javier
>