From mboxrd@z Thu Jan 1 00:00:00 1970 From: Andrew Lunn Subject: [Patch v3] 0/7] Remove mach-kirkwood Date: Sat, 30 Aug 2014 18:46:05 +0200 Message-ID: <1409417172-6846-1-git-send-email-andrew@lunn.ch> Return-path: Sender: linux-ide-owner@vger.kernel.org To: Jason Cooper Cc: linux ARM , Andrew Lunn , Daniel Lezcano , "Rafael J. Wysocki" , linux-pm@vger.kernel.org, Tejun Heo , linux-ide@vger.kernel.org, Zhang Rui , Richard Purdie , linux-leds@vger.kernel.org, Alessandro Zummo , rtc-linux@googlegroups.com, Wim Van Sebroeck , linux-watchdog@vger.kernel.org, Viresh Kumar List-Id: linux-leds@vger.kernel.org This is mostly a resend of these patches, removing mach-kirkwood. Not all maintainers picked up there patches, which has resulted in some dead kernel configuration in v3.17-rcX. The patch set has been rebased on v3.17-rc2, and it is intended that Jason Cooper will submit them for inclusion in an RC. Subsystem maintainers do not need to do anything. The last patch "cpufreq: Remove ARCH_KIRKWOOD dependency" is new, since what it is removing was added during v3.16-rcX. It follows the pattern of all the other patches. Andrew Lunn (7): cpuidle: kirkwood: Remove ARCH_KIRKWOOD dependency ata: Remove ARCH_KIRKWOOD dependency thermal: Remove ARCH_KIRKWOOD dependency leds: Remove ARCH_KIRKWOOD dependency rtc: Remove ARCH_KIRKWOOD dependency watchdog: Remove ARCH_KIRKWOOD dependency cpufreq: Remove ARCH_KIRKWOOD dependency drivers/ata/Kconfig | 2 +- drivers/cpufreq/Kconfig.arm | 2 +- drivers/cpuidle/Kconfig.arm | 2 +- drivers/leds/Kconfig | 4 ++-- drivers/rtc/Kconfig | 2 +- drivers/thermal/Kconfig | 2 +- drivers/watchdog/Kconfig | 2 +- 7 files changed, 8 insertions(+), 8 deletions(-) -- 2.1.0 Cc: Daniel Lezcano Cc: Rafael J. Wysocki Cc: linux-pm@vger.kernel.org Cc: Tejun Heo Cc: linux-ide@vger.kernel.org Cc: Zhang Rui Cc: linux-pm@vger.kernel.org Cc: Richard Purdie Cc: linux-leds@vger.kernel.org Cc: Alessandro Zummo Cc: rtc-linux@googlegroups.com Cc: Wim Van Sebroeck Cc: linux-watchdog@vger.kernel.org Cc: Viresh Kumar