messages from 2026-09-10 18:15:50 to 2026-09-16 06:09:27 UTC [more...]
[PATCH v3] dt-bindings: leds: lacie,netxbig-leds: Convert to DT schema
2026-09-16 6:09 UTC (6+ messages)
[PATCH v7 0/3] Samsung Expressatt: Camera Flash
2026-09-15 20:25 UTC (11+ messages)
` [PATCH v7 1/3] dt-bindings: leds: rt8515: Support single-GPIO flash ICs with vin supply
` [PATCH v7 2/3] leds: flash: "
` [PATCH v7 3/3] ARM: dts: qcom: msm8960: expressatt: Add camera flash
[PATCH v2 1/8] dt-bindings: leds: pca995x: Describe reset-gpios property
2026-09-15 14:48 UTC (17+ messages)
` [PATCH v2 2/8] dt-bindings: leds: pca995x: Describe nxp,output-gain property
` [PATCH v2 3/8] leds: pca995x: Fix maximum LED index for 16-channel variants
` [PATCH v2 4/8] leds: pca995x: Add support for reset GPIO
` [PATCH v2 5/8] leds: pca995x: Make output gain configurable
` [PATCH v2 6/8] leds: pca995x: Add sysfs files for error reporting
` [PATCH v2 7/8] leds: pca995x: Do not use full on LED mode
` [PATCH v2 8/8] leds: pca995x: Add support for group brightness control
[PATCH v2 00/13] leds: st1202: Naming cleanups and pre-existing fixes
2026-09-15 13:23 UTC (28+ messages)
` [PATCH v2 01/13] leds: st1202: Correct the name of the prescaler conversion helper
` [PATCH v2 02/13] leds: st1202: Spell out the phase-shift configuration bit
` [PATCH v2 03/13] leds: st1202: Name pattern index variables consistently
` [PATCH v2 04/13] leds: st1202: Use u8 consistently for 8-bit values
` [PATCH v2 05/13] leds: st1202: Clear unused pattern slots in pattern_set()
` [PATCH v2 06/13] leds: st1202: Scale pattern brightness to the 12-bit PWM range
` [PATCH v2 07/13] leds: st1202: Program the channel current for hardware patterns
` [PATCH v2 08/13] leds: st1202: Take a reference on the LED firmware node
` [PATCH v2 09/13] leds: st1202: Do not set brightness from atomic context
` [PATCH v2 10/13] leds: st1202: Clear unused pattern slots in blink_set()
` [PATCH v2 11/13] leds: st1202: Honour max_brightness when blinking
` [PATCH v2 12/13] leds: st1202: Cap the channel current in st1202_led_set()
` [PATCH v2 13/13] leds: st1202: Give the channel current ceiling a single helper
[PATCH RFC v4 0/1] leds: asus-aura-scsi: Add ASUS Aura RGB LED driver for ROG NVMe enclosures
2026-09-15 13:00 UTC (3+ messages)
` [PATCH RFC v4 1/1] "
[PATCH RFC 0/1] leds: add ASUS Aura SCSI driver for ROG NVMe enclosures
2026-09-15 12:49 UTC (12+ messages)
` [PATCH RFC 1/1] "
` [PATCH RFC v2 0/1] leds: asus-aura-scsi: Add ASUS Aura RGB LED "
` [PATCH RFC v2 1/1] "
` [PATCH RFC v3 0/1] "
` [PATCH RFC v3 1/1] "
[PATCH v1 00/11] leds: st1202: Naming cleanups and pre-existing fixes
2026-09-15 12:00 UTC (31+ messages)
` [PATCH v1 01/11] leds: st1202: Correct the name of the prescaler conversion helper
` [PATCH v1 02/11] leds: st1202: Spell out the phase-shift configuration bit
` [PATCH v1 03/11] leds: st1202: Name pattern index variables consistently
` [PATCH v1 04/11] leds: st1202: Use u8 consistently for 8-bit values
` [PATCH v1 05/11] leds: st1202: Clear unused pattern slots in pattern_set()
` [PATCH v1 06/11] leds: st1202: Scale pattern brightness to the 12-bit PWM range
` [PATCH v1 07/11] leds: st1202: Program the channel current for hardware patterns
` [PATCH v1 08/11] leds: st1202: Take a reference on the LED firmware node
` [PATCH v1 09/11] leds: st1202: Do not set brightness from atomic context
` [PATCH v1 10/11] leds: st1202: Clear unused pattern slots in blink_set()
` [PATCH v1 11/11] leds: st1202: Honour max_brightness when blinking
[PATCH RFC 00/10] arm64: qcom: sm6125-ginkgo: display, backlight, and touch support
2026-09-15 11:15 UTC (25+ messages)
` [PATCH RFC 01/10] dt-bindings: backlight: add Kinetic KTD3136
` [PATCH RFC 02/10] backlight: add Kinetic KTD3136 driver
` [PATCH RFC 03/10] dt-bindings: display: panel: novatek,nt36672a: add Tianma FHD+ video mode variant
` [PATCH RFC 04/10] drm/panel: novatek-nt36672a: add Tianma FHD+ video mode panel
` [PATCH RFC 05/10] dt-bindings: input: touchscreen: add Novatek NT36672A SPI touchscreen
` [PATCH RFC 06/10] Input: novatek-nt36672a-spi: add driver for "
` [PATCH RFC 07/10] drm/msm/dpu: describe SM6125 programmable-fetch delayed-start quirk
` [PATCH RFC 08/10] drm/msm/dsi: make command and video mode configuration mutually exclusive
` [PATCH RFC 09/10] drm/msm/dsi: separate host link enable from video stream enable
` [PATCH RFC 10/10] arm64: dts: qcom: sm6125-xiaomi-ginkgo: enable display, backlight and touchscreen
[PATCH 1/7] dt-bindings: leds: pca995x: describe reset-gpios property
2026-09-15 10:28 UTC (7+ messages)
` [PATCH 2/7] dt-bindings: leds: pca995x: describe output-gain property
[PATCH] leds: lm3692x: fix regulator/gpio leak and wrong enabled state on last write failure
2026-09-15 3:52 UTC (2+ messages)
[PATCH] leds: blinkm: Remove sysfs group on allocation failure
2026-09-15 2:12 UTC (2+ messages)
[PATCH] leds: pca9532: check i2c_smbus_read_byte_data() return value
2026-09-14 19:46 UTC (2+ messages)
[PATCH 0/3] leds: trigger: netdev: fix sysfs_update_group() races
2026-09-14 17:05 UTC (9+ messages)
` [PATCH 1/3] leds: trigger: netdev: hold lock across sysfs_update_group() in device_name_store()
` [PATCH 2/3] leds: trigger: netdev: fix sysfs_update_group() vs led_trigger_set() races
` [PATCH 3/3] leds: trigger: netdev: serialize mode/interval stores with trigger lock
[PATCH] leds: ncp5623: release multi-led fwnode on remove
2026-09-14 14:27 UTC (3+ messages)
[PATCH] leds: flash: sgm3140: fix child node reference leak
2026-09-14 14:25 UTC (3+ messages)
[PATCH v25 0/4] rust: leds: add led classdev abstractions
2026-09-13 16:31 UTC (9+ messages)
` [PATCH v25 1/4] rust: leds: add basic "
` [PATCH v25 2/4] rust: leds: add Mode trait
` [PATCH v25 3/4] rust: leds: add multicolor classdev abstractions
` [PATCH v25 4/4] MAINTAINERS: rust: leds: Add rust abstraction entry
[PATCH] dt-bindings: leds: Use consistent indentation in the example
2026-09-13 12:34 UTC (2+ messages)
[PATCH 08/14] mfd: remove unused aat2870 driver
2026-09-13 8:33 UTC (8+ messages)
[PATCH 00/14] mfd: unused driver purge
2026-09-11 7:24 UTC (3+ messages)
` [PATCH 01/14] mfd: remove unused 88pm80x driver
[PATCH v13 0/2] Add support for LTC3208 multi-display driver
2026-09-11 0:08 UTC (5+ messages)
` [PATCH v13 1/2] dt-bindings: leds: Document LTC3208 Multidisplay LED Driver
` [PATCH v13 2/2] leds: ltc3208: Add driver for "
[PATCH v12 0/2] Add support for LTC3208 multi-display driver
2026-09-10 23:54 UTC (5+ messages)
` [PATCH v12 1/2] dt-bindings: leds: Document LTC3208 Multidisplay LED Driver
` [PATCH v12 2/2] leds: ltc3208: Add driver for "
[PATCH v11 0/2] Add support for LTC3208 multi-display driver
2026-09-10 22:51 UTC (4+ messages)
` [PATCH v11 2/2] leds: ltc3208: Add driver for LTC3208 Multidisplay LED Driver
[PATCH 00/15] HID: hid-oxp: fix and extend X2-family controller support
2026-09-10 20:24 UTC (28+ messages)
` [PATCH 02/15] HID: hid-oxp: validate input report lengths before decoding
` [PATCH 03/15] HID: hid-oxp: retain fractional brightness when reading RGB status
` [PATCH 04/15] HID: hid-oxp: reject invalid Gen2 RGB status values
` [PATCH 05/15] HID: hid-oxp: fix multicolor LED intensity scaling
` [PATCH 06/15] HID: hid-oxp: serialize complete RGB updates
` [PATCH 07/15] HID: hid-oxp: select brightness policy for the new RGB effect
` [PATCH 08/15] HID: hid-oxp: stop configuration work during teardown
` [PATCH 09/15] HID: hid-oxp: keep configuration state per HID interface
` [PATCH 10/15] HID: hid-oxp: handle controller reinitialization across suspend
` [PATCH 11/15] HID: hid-oxp: group declarations and protocol definitions
` [PATCH 13/15] HID: hid-oxp: represent RGB LEDs with a common array
` [PATCH 14/15] HID: hid-oxp: add Gen3 joystick ring RGB support
` [PATCH 15/15] HID: hid-oxp: add X2 auxiliary RGB zones
[PATCH] leds: ktd2692: Pass context to regulator cleanup
2026-09-10 19:56 UTC (2+ messages)
[PATCH] leds: lp8860: fix device_node leak in lp8860_probe()
2026-09-10 19:52 UTC (2+ messages)
[PATCH v6 00/12] leds: Add support for hardware-initiated hardware control trigger transition
2026-09-10 18:17 UTC (4+ messages)
` [PATCH v6 09/12] leds: trigger: Add led_trigger_notify_hw_control_changed() interface
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).