From: Angelo Dureghello <angelo@sysam.it>
To: Greg Ungerer <gregungerer@westnet.com.au>, linux-m68k@vger.kernel.org
Subject: Re: [PATCH] m68k/defconfig: amcore board defconfig tuning
Date: Mon, 9 Jan 2017 10:38:29 +0100 [thread overview]
Message-ID: <16355760-9608-6220-65f2-44dd2abb2e28@sysam.it> (raw)
In-Reply-To: <6a8520f4-fc2a-afb4-7b56-fc2bff3627fb@westnet.com.au>
Hi Greg,
On 09/01/2017 06:43, Greg Ungerer wrote:
> Hi Angelo,
>
> On 04/01/17 09:27, Angelo Dureghello wrote:
>> Signed-off-by: Angelo Dureghello <angelo@sysam.it>
>> ---
>> arch/m68k/configs/amcore_defconfig | 14 ++++++++------
>> 1 file changed, 8 insertions(+), 6 deletions(-)
>
> No problem with the change.
> But can you provide more information in the log message?
> What tuning are the changes achieving?
well, the change was driven mainly since i couldn't have
tcp accept working with recent mainline kernels until i enabled
CONFIG_SYN_COOKIES. With CONFIG_SYN_COOKIES tcp accept works
again, will try to go deeper a bit on this since i believe
tcp accepts should work also without CONFIG_SYN_COOKIES.
I also had the chance to "diet" a bit kernel size and enable
sysfs gpio.
I'll resend v2 later.
>
> Thanks
> Greg
>
>
Thanks,
Regards,
angelo dureghello
>
>> diff --git a/arch/m68k/configs/amcore_defconfig b/arch/m68k/configs/amcore_defconfig
>> index f108dd1..131b410 100644
>> --- a/arch/m68k/configs/amcore_defconfig
>> +++ b/arch/m68k/configs/amcore_defconfig
>> @@ -1,19 +1,20 @@
>> -CONFIG_LOCALVERSION="amcore-001"
>> +CONFIG_LOCALVERSION="amcore-002"
>> CONFIG_DEFAULT_HOSTNAME="amcore"
>> CONFIG_SYSVIPC=y
>> # CONFIG_FHANDLE is not set
>> # CONFIG_USELIB is not set
>> CONFIG_LOG_BUF_SHIFT=14
>> -CONFIG_NAMESPACES=y
>> CONFIG_CC_OPTIMIZE_FOR_SIZE=y
>> # CONFIG_AIO is not set
>> # CONFIG_ADVISE_SYSCALLS is not set
>> # CONFIG_MEMBARRIER is not set
>> CONFIG_EMBEDDED=y
>> # CONFIG_VM_EVENT_COUNTERS is not set
>> +# CONFIG_SLUB_DEBUG is not set
>> # CONFIG_COMPAT_BRK is not set
>> # CONFIG_LBDAF is not set
>> # CONFIG_BLK_DEV_BSG is not set
>> +# CONFIG_IOSCHED_CFQ is not set
>> # CONFIG_MMU is not set
>> CONFIG_M5307=y
>> CONFIG_AMCORE=y
>> @@ -27,13 +28,14 @@ CONFIG_NET=y
>> CONFIG_PACKET=y
>> CONFIG_UNIX=y
>> CONFIG_INET=y
>> +CONFIG_SYN_COOKIES=y
>> # CONFIG_INET_XFRM_MODE_TRANSPORT is not set
>> # CONFIG_INET_XFRM_MODE_TUNNEL is not set
>> # CONFIG_INET_XFRM_MODE_BEET is not set
>> # CONFIG_IPV6 is not set
>> # CONFIG_WIRELESS is not set
>> # CONFIG_UEVENT_HELPER is not set
>> -CONFIG_FW_LOADER_USER_HELPER_FALLBACK=y
>> +# CONFIG_FW_LOADER is not set
>> # CONFIG_ALLOW_DEV_COREDUMP is not set
>> CONFIG_CONNECTOR=y
>> CONFIG_MTD=y
>> @@ -53,6 +55,7 @@ CONFIG_MTD_UCLINUX=y
>> CONFIG_MTD_PLATRAM=y
>> CONFIG_BLK_DEV_RAM=y
>> CONFIG_NETDEVICES=y
>> +# CONFIG_NET_VENDOR_AMAZON is not set
>> # CONFIG_NET_VENDOR_ARC is not set
>> # CONFIG_NET_CADENCE is not set
>> # CONFIG_NET_VENDOR_BROADCOM is not set
>> @@ -89,14 +92,12 @@ CONFIG_I2C=y
>> CONFIG_I2C_CHARDEV=y
>> # CONFIG_I2C_HELPER_AUTO is not set
>> CONFIG_I2C_IMX=y
>> -CONFIG_PPS=y
>> +CONFIG_GPIO_SYSFS=y
>> # CONFIG_HWMON is not set
>> # CONFIG_USB_SUPPORT is not set
>> CONFIG_RTC_CLASS=y
>> # CONFIG_RTC_SYSTOHC is not set
>> CONFIG_RTC_DRV_DS1307=y
>> -CONFIG_EXT2_FS=y
>> -CONFIG_EXT2_FS_XATTR=y
>> # CONFIG_FILE_LOCKING is not set
>> # CONFIG_DNOTIFY is not set
>> # CONFIG_INOTIFY_USER is not set
>> @@ -108,6 +109,7 @@ CONFIG_ROMFS_BACKED_BY_BOTH=y
>> # CONFIG_NETWORK_FILESYSTEMS is not set
>> CONFIG_PRINTK_TIME=y
>> # CONFIG_ENABLE_WARN_DEPRECATED is not set
>> +# CONFIG_ENABLE_MUST_CHECK is not set
>> # CONFIG_SECTION_MISMATCH_WARN_ONLY is not set
>> CONFIG_PANIC_ON_OOPS=y
>> # CONFIG_SCHED_DEBUG is not set
>>
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-m68k" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
>
next prev parent reply other threads:[~2017-01-09 9:38 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-01-03 23:27 [PATCH] m68k/defconfig: amcore board defconfig tuning Angelo Dureghello
2017-01-09 5:43 ` Greg Ungerer
2017-01-09 9:38 ` Angelo Dureghello [this message]
2017-01-09 12:04 ` Greg Ungerer
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=16355760-9608-6220-65f2-44dd2abb2e28@sysam.it \
--to=angelo@sysam.it \
--cc=gregungerer@westnet.com.au \
--cc=linux-m68k@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox