[PATCH v4 01/18] ARM: orion/gpio: Use the right include

Andy Shevchenko
2023-02-08T17:33:50Z

From: Linus Walleij <linus.walleij@linaro.org>

This is a GPIO driver so include <linux/gpio/driver.h> and not
the legacy <linux/gpio.h> header. Switch a single call to the
legacy API and use <linux/gpio/consumer.h> as well.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
arch/arm/plat-orion/gpio.c | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/arch/arm/plat-orion/gpio.c b/arch/arm/plat-orion/gpio.c
index 3ef9ecdd6343..595e9cb33c1d 100644
--- a/arch/arm/plat-orion/gpio.c
+++ b/arch/arm/plat-orion/gpio.c
@@ -18,7 +18,8 @@
#include <linux/spinlock.h>
#include <linux/bitops.h>
#include <linux/io.h>
-#include <linux/gpio.h>
+#include <linux/gpio/driver.h>
+#include <linux/gpio/consumer.h>
#include <linux/leds.h>
#include <linux/of.h>
#include <linux/of_irq.h>
@@ -312,7 +313,7 @@ int orion_gpio_led_blink_set(struct gpio_desc *desc, int state,
case GPIO_LED_NO_BLINK_LOW:
case GPIO_LED_NO_BLINK_HIGH:
orion_gpio_set_blink(gpio, 0);
- gpio_set_value(gpio, state);
+ gpiod_set_raw_value(desc, state);
break;
case GPIO_LED_BLINK:
orion_gpio_set_blink(gpio, 1);
--
2.39.1