Re: [uClinux-dev] [PATCH m68knommu] Add the m54xx fec driver

[Greg Ungerer <gregungerer@westnet.com.au>]

On 31/05/14 12:09, Steven King wrote:
> On Monday 24 September 2012 1:05:16 am Philippe De Muyter wrote:
>> Hello,
>>
>> I have cleaned up and updated to 3.6-rc5 my previous port of the
>> freescale-written driver for the fast Ethernet Controller of the M547x
>> and M548x ColdFires.  It seems from comments found in Freescale sources
>> that this uses a MultiChannel DMA controller marketed as MCD and available
>> also in the NPC8220 also from Freescale.  Therefore, I have split the
>> submission in three parts :
>> 	A generic MCD dma driver
>> 	The M54xx instantiation of the MCD driver
>> 	The FEC driver for M54xx
>>
>> I know there are still lines above 80 characters, but I feel they must be
>> left that way.  There are also parts of an unfinished netpoll interface.
>>
>> Feel free to test and comment.
> 
> So whatever happened with this?  Was there ever any feedback from the other 
> maintainers?
> 
> For what it is worth, I was able to take the original patches and rebase them 
> to v3.15-rc6 with just a couple of very minor changes and produce a working 
> ethernet for my 5484 system.

I don't recall seeing too much. Time to try again?

Regards
Greg