1:/> vmlinux-6.4.10+wrs console=ttyS0,115200n8 netdev=5,0x300,eth0 root=/dev/sdb3
vmlinux-6.4.10+wrs: 6482816 bytes, ELF.
Loading 4637888 bytes from file offset 0x1000 to memory at 0x41000
Loading 120836 bytes from file offset 0x46E000 to memory at 0x4CE000
Linux kernel detected: creating bootinfo at 0x4EC000
Entry at 0x42000 in supervisor mode
[    0.000000] Linux version 6.4.10-wrs (btg@carbon) (m68k-linux-gnu-gcc (Debian 12.2.0-13) 12.2.0, GNU ld (GNU Binutils for Debian) 2.40) #1 Sun Aug 13 22:32:30 BST 2023
[    0.000000] Zone ranges:
[    0.000000]   DMA      [mem 0x0000000000040000-0x0000001fffffffff]
[    0.000000]   Normal   empty
[    0.000000] Movable zone start for each node
[    0.000000] Early memory node ranges
[    0.000000]   node   0: [mem 0x0000000000040000-0x0000000001ffffff]
[    0.000000] Initmem setup node 0 [mem 0x0000000000040000-0x0000000001ffffff]
[    0.000000] Kernel command line: console=ttyS0,115200n8 netdev=5,0x300,eth0 root=/dev/sdb3
[    0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes, linear)
[    0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes, linear)
[    0.000000] Sorting __ex_table...
[    0.000000] Built 1 zonelists, mobility grouping on.  Total pages: 8056
[    0.000000] mem auto-init: stack:off, heap alloc:off, heap free:off
[    0.000000] Memory: 27340K/32512K available (3220K kernel code, 442K rwdata, 988K rodata, 120K init, 129K bss, 5172K reserved, 0K cma-reserved)
[    0.000000] NR_IRQS: 43
[    0.010000] Console: colour dummy device 80x25
[    0.010000] printk: console [ttyS0] enabled
[    0.100000] Calibrating delay loop... 26.16 BogoMIPS (lpj=130816)
[    0.210000] pid_max: default: 32768 minimum: 301
[    0.220000] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
[    0.230000] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
[    0.270000] cblist_init_generic: Setting adjustable number of callback queues.
[    0.270000] cblist_init_generic: Setting shift to 0 and lim to 1.
[    0.290000] devtmpfs: initialized
[    0.320000] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[    0.320000] futex hash table entries: 256 (order: -1, 3072 bytes, linear)
[    0.360000] NET: Registered PF_NETLINK/PF_ROUTE protocol family
[    0.370000] DMA: preallocated 128 KiB GFP_KERNEL pool for atomic allocations
[    0.380000] DMA: preallocated 128 KiB GFP_KERNEL|GFP_DMA pool for atomic allocations
[    0.440000] SCSI subsystem initialized
[    0.800000] NET: Registered PF_INET protocol family
[    0.810000] IP idents hash table entries: 2048 (order: 2, 16384 bytes, linear)
[    0.840000] tcp_listen_portaddr_hash hash table entries: 1024 (order: 0, 4096 bytes, linear)
[    0.840000] Table-perturb hash table entries: 65536 (order: 6, 262144 bytes, linear)
[    0.850000] TCP established hash table entries: 1024 (order: 0, 4096 bytes, linear)
[    0.850000] TCP bind hash table entries: 1024 (order: 1, 8192 bytes, linear)
[    0.860000] TCP: Hash tables configured (established 1024 bind 1024)
[    0.860000] UDP hash table entries: 256 (order: 0, 4096 bytes, linear)
[    0.870000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes, linear)
[    0.880000] NET: Registered PF_UNIX/PF_LOCAL protocol family
[    0.900000] workingset: timestamp_bits=30 max_order=13 bucket_order=0
[    1.300000] fb0: Q40 frame buffer alive and kicking !
[    1.310000] Serial: 8250/16550 driver, 8 ports, IRQ sharing disabled
[    1.320000] serial8250: ttyS0 at I/O 0x3f8 (irq = 4, base_baud = 115200) is a 16450
[    1.340000] serial8250: ttyS1 at I/O 0x2f8 (irq = 3, base_baud = 115200) is a 16450
[    1.560000] loop: module loaded
[    1.570000] atari-falcon-ide atari-falcon-ide.0: Atari Falcon and Q40/Q60 PATA controller
[    1.590000] scsi host0: pata_falcon
[    1.600000] ata1: PATA max PIO4 cmd 0x1f0 ctl 0x3f6 irq 14
[    1.610000] atari-falcon-ide atari-falcon-ide.1: Atari Falcon and Q40/Q60 PATA controller
[    1.650000] scsi host1: pata_falcon
[    1.660000] ata2: PATA max PIO4 cmd 0x170 ctl 0x376 irq 15
[    1.760000] ne ne.0 (unnamed net_device) (uninitialized): NE*000 ethercard probe at 0x300:
[    1.760000] 00:00:e8:cf:2e:39
[    1.780000] ne ne.0 eth0: RTL8019 found at 0x300, using IRQ 5.
[    1.790000] PPP generic driver version 2.4.2
[    1.810000] serio: Q40 kbd registered
[    1.840000] NET: Registered PF_INET6 protocol family
[    1.870000] input: AT Raw Set 2 keyboard as /devices/platform/q40kbd/serio0/input/input0
[    1.910000] Segment Routing with IPv6
[    1.920000] In-situ OAM (IOAM) with IPv6
[    2.110000] ata1.00: CFA: InnoDisk Corp. - iCF4000 2GB, 080414S4, max UDMA/66
[    2.110000] ata1.00: 4095504 sectors, multi 2: LBA 
[    2.120000] ata1.01: CFA: SDCFHS-016G, HDX13.04, max UDMA/100
[    2.120000] ata1.01: 31293360 sectors, multi 0: LBA48 
[    2.140000] ata1.00: configured for PIO
[    2.140000] ata1.01: configured for PIO
[    2.150000] scsi 0:0:0:0: Direct-Access     ATA      InnoDisk Corp. - 14S4 PQ: 0 ANSI: 5
[    2.190000] scsi 0:0:1:0: Direct-Access     ATA      SDCFHS-016G      3.04 PQ: 0 ANSI: 5
[    2.230000] sd 0:0:0:0: [sda] 4095504 512-byte logical blocks: (2.10 GB/1.95 GiB)
[    2.230000] sd 0:0:0:0: [sda] Write Protect is off
[    2.240000] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[    2.250000] sd 0:0:0:0: [sda] Preferred minimum I/O size 512 bytes
[    2.260000] sd 0:0:1:0: [sdb] 31293360 512-byte logical blocks: (16.0 GB/14.9 GiB)
[    2.280000] sd 0:0:1:0: [sdb] Write Protect is off
[    2.280000] sd 0:0:1:0: [sdb] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[    2.290000] sd 0:0:1:0: [sdb] Preferred minimum I/O size 512 bytes
[    2.360000] sd 0:0:0:0: [sda] Attached SCSI disk
[    2.370000]  sdb: sdb1 sdb2 sdb3
[    2.400000] sd 0:0:1:0: [sdb] Attached SCSI removable disk
[    2.460000] EXT4-fs (sdb3): INFO: recovery required on readonly filesystem
[    2.470000] EXT4-fs (sdb3): write access will be enabled during recovery
[    2.730000] EXT4-fs (sdb3): recovery complete
[    2.760000] EXT4-fs (sdb3): mounted filesystem f8a23063-b7c5-46f5-8693-5e1ae0b418b0 ro with ordered data mode. Quota mode: disabled.
[    2.760000] VFS: Mounted root (ext4 filesystem) readonly on device 8:19.
[    2.780000] devtmpfs: mounted
[    2.780000] Freeing unused kernel image (initmem) memory: 120K
[    2.790000] This architecture does not have kernel memory protection.
[    2.790000] Run /sbin/init as init process
[    3.910000] EXT4-fs (sdb3): re-mounted f8a23063-b7c5-46f5-8693-5e1ae0b418b0 r/w. Quota mode: disabled.
Starting syslogd: OK
Starting klogd: OK