[PATCH v7 1/4] smartpqi: update host attribute descriptions

[Don Brace <don.brace@microchip.com>]

Minor description changes for host attributes.

Just some small changes to the host attribute descriptions.
Remove the "version" sysfs entry. This entry was changed
to two sysfs entries: driver_version and firmware_version.

Reviewed-by: Scott Benesh <scott.benesh@microchip.com>
Reviewed-by: Scott Teel <scott.teel@microchip.com>
Reviewed-by: Mike McGowen <mike.mcgowen@microchip.com>
Reviewed-by: Kevin Barnett <kevin.barnett@microchip.com>
Signed-off-by: Don Brace <don.brace@microchip.com>
---
 man4/smartpqi.4 | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/man4/smartpqi.4 b/man4/smartpqi.4
index 393545d3728d..1e5b6d76f548 100644
--- a/man4/smartpqi.4
+++ b/man4/smartpqi.4
@@ -138,12 +138,12 @@ The host
 attribute is a write-only attribute.
 Writing to this attribute will cause the driver to scan for new,
 changed, or removed devices (e.g., hot-plugged tape drives, or newly
-configured or deleted logical drives) and notify the SCSI mid-layer of
+configured or deleted logical volumes) and notify the SCSI mid-layer of
 any changes detected.
 Usually this action is triggered automatically by configuration
 changes, so the user should not normally have to write to this file.
 Doing so may be useful when hot-plugging devices such as tape drives or
-entire storage boxes containing pre-configured logical drives.
+entire storage boxes containing pre-configured logical volumes.
 .TP
 .IR /sys/class/scsi_host/host * /version
 The host
-- 
2.42.0.345.gaab89be2eb