From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from 203.161.84.42.static.amnet.net.au ([203.161.84.42] helo=goeng.com.au) by www.linuxtv.org with esmtp (Exim 4.63) (envelope-from ) id 1KYHzX-0000F7-EK for linux-dvb@linuxtv.org; Wed, 27 Aug 2008 12:11:08 +0200 From: "Thomas Goerke" To: stev391@email.com References: <20080827061320.298E2104F0@ws1-3.us4.outblaze.com> In-Reply-To: <20080827061320.298E2104F0@ws1-3.us4.outblaze.com> Date: Wed, 27 Aug 2008 18:11:35 +0800 Message-ID: <003201c9082d$4b7fff80$e27ffe80$@com.au> MIME-Version: 1.0 Content-Language: en-au Cc: linux-dvb@linuxtv.org Subject: Re: [linux-dvb] Compro VideoMate E650 hybrid PCIe DVB-T and analog TV/FM capture card List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Sender: linux-dvb-bounces@linuxtv.org Errors-To: linux-dvb-bounces+mchehab=infradead.org@linuxtv.org List-ID: > Thanks for doing that, it appears that the two cards (E800F and E650) > have the same subvendor and product ids. Also the same i2c output... > > So this means that if I make a patch for DVB support in one, it will > automatically be loaded for the other. This however does pose a > dilemma when looking at the analog side of the card. However this can > be hopefully tackled at a later stage. > > The key registers that I'm after are the states of: > VID_A_INT_MSK > VID_B_INT_MSK > VID_C_INT_MSK > > As I need to determine which port has the digital stream connected to > it. > > Typically these are zero when not in use, so if you run the program > when the tuner is not in use then run the DVB program you should see a > change in state of one of these only. > > Can you also tune to an analog channel as well and let me know which > one it is on (a, b or c). > > Thanks, > > Stephen. > > > -- > Be Yourself @ mail.com! > Choose From 200+ Email Addresses > Get a Free Account at www.mail.com Stephen, I managed to install a copy of D-scaler (v4.1.11) which contained regspy from http://www.dscaler.org/downloads.htm, but was unable to get regspy nor d-scaler to recognize the Compro E800 card. Thus I have been unable to get the register dump you requested. I can try again if you think that regspy can be made to work with the card and any suggestions here would be appreciated. Tom _______________________________________________ linux-dvb mailing list linux-dvb@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb