From: Stu Fleming <stewart@wic.co.nz>
To: linux-media@vger.kernel.org
Subject: Re: [linux-dvb] Optus D1 tuning?
Date: Sat, 30 Apr 2011 21:16:30 +1200 [thread overview]
Message-ID: <1304154990.3962.48.camel@media-centre> (raw)
In-Reply-To: <BANLkTikXWx-E_rOyEb47S1TFfh3KBd0oNw@mail.gmail.com>
I used http://www.wlug.org.nz/FreeViewMythTvSetup as a guide to set up
my Freeview on Mythtv.
Hope this helps.
Regards,
Stu
On Sat, 2011-04-30 at 21:05 +1200, Morgan Read wrote:
> Hello list
>
> I've been trying to connect to the Optus D1 satellite from NZ, and I'm
> tearing my hair out.
>
> There is no config file dvb-apps/dvb-s so I've constructed the following from:
> http://www.lyngsat.com/optusd1.html
>
> # Optus D1 satellite 160E
> # freq pol sr fec
>
> ### Freeview: DVB-S, Prime TV, Shine TV, C4, TV 3, Four, Stratos,
> Parliament TV, Cue TV, Te Reo, TV 3 +1
> S 12456000 H 22500000 3/4
> ### Freeview: DVB-S, Maori TV, TVNZ TV One Auckland, TVNZ TV 2, TVNZ7,
> TVNZ U, TVNZ TV One Hamilton, TVNZ TV One Wellington, TVNZ TV One
> Christchurch
> S 12483000 H 22500000 3/4
>
> ### DVB-S2, Channel Nine, GEM, Go!
> S 12398000 V 11909000 2/3
> ### SBS Tasmania: DVB-S, SBS One Tasmania, SBS Two Tasmania, SBS One
> Tasmania HD, SBS Radio Tasmania AM, SBS Radio Tasmania FM
> S 12648000 V 12600000 5/6
>
> ### Sky New Zealand: DVB-S2 Videoguard
> S 12267000 H 22500000 2/3
> S 12331000 H 22500000 2/3
> S 12358000 H 22500000 2/3
> ### Sky New Zealand: DVB-S Videoguard
> S 12394000 H 22500000 3/4
> S 12421000 H 22500000 3/4
> ### Sky New Zealand: DVB-S Videoguard, Radio New Zealand National,
> Radio New Zealand Concert, Niu FM, Tahu FM
> S 12519000 H 22500000 3/4
> ### Sky New Zealand: DVB-S Videoguard, Calvary Chapel Radio New Zealand
> S 12546000 H 22500000 3/4
> ### Sky New Zealand: DVB-S Videoguard, The Edge FM
> S 12581000 H 22500000 3/4
> ### Sky New Zealand: DVB-S Videoguard, Maori TV
> S 12608000 H 22500000 3/4
> ### Sky New Zealand: DVB-S Videoguard
> S 12644000 H 22500000 3/4
> ### Sky New Zealand: DVB-S Videoguard, TVNZ TV One, TVNZ TV 2, Trackside
> S 12671000 H 22500000 3/4
> ### Sky New Zealand: DVB-S Videoguard
> S 12707000 H 22500000 3/4
> S 12734000 H 22500000 3/4
>
> It's heavily annotated with channel info, but if it could be included
> in dvb-apps/dvb-s I'm sure it could put somebody else out of the
> misery I've been suffering.
>
> If I run w_scan to search for channels it times out, but if I use
> dvbtune and scandvb I get some (but not all) channels discovered. See
> below. I feel like I'm flailing about in a dark pit, if anybody could
> help me out it would be much appreciated!
>
> Many thanks,
> Morgan.
>
> [vortexbox.lan ~]# w_scan -fs -s S160E0 -x
> w_scan version 20110206 (compiled for DVB API 5.2)
> using settings for 160.0 east Optus D1
> frontend_type DVB-S, channellist 49
> output format initial tuning data
> Info: using DVB adapter auto detection.
> /dev/dvb/adapter0/frontend0 -> DVB-S "Conexant CX24123/CX24109": good :-)
> Using DVB-S frontend (adapter /dev/dvb/adapter0/frontend0)
> -_-_-_-_ Getting frontend capabilities-_-_-_-_
> Using DVB API 5.2
> frontend Conexant CX24123/CX24109 supports
> INVERSION_AUTO
> DVB-S
> using LNB "UNIVERSAL"
> -_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_
> 12331: skipped (no driver support)
> 12358: skipped (no driver support)
> (time: 00:00)
> (time: 00:03)
> ...
> (time: 01:16)
> (time: 01:19)
>
> ERROR: Sorry - i couldn't get any working frequency/transponder
> Nothing to scan!!
> [vortexbox.lan ~]# dvbtune -f 1183000 -s 22500 -p h -m
> Using DVB card "Conexant CX24123/CX24109"
> tuning DVB-S to L-Band:0, Pol:H Srate=22500000, 22kHz=off
> ERROR setting tone
> : Invalid argument
> polling....
> Getting frontend event
> Overflow error, trying again (status = -1, errno = 75)FE_STATUS:
> polling....
> Getting frontend event
> FE_STATUS:
> polling....
> Getting frontend event
> FE_STATUS: FE_HAS_SIGNAL
> polling....
> Getting frontend event
> FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER FE_HAS_VITERBI FE_HAS_SYNC
> Bit error rate: 0
> Signal strength: 61952
> SNR: 57884
> FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER FE_HAS_VITERBI FE_HAS_SYNC
> FE READ UNCORRECTED BLOCKS: : Operation not supported
> Signal=61952, Verror=0, SNR=57609dB, BlockErrors=0, (S|L|C|V|SY|)
> FE READ UNCORRECTED BLOCKS: : Operation not supported
> Signal=61952, Verror=0, SNR=57473dB, BlockErrors=0, (S|L|C|V|SY|)
> FE READ UNCORRECTED BLOCKS: : Operation not supported
> Signal=61952, Verror=0, SNR=57835dB, BlockErrors=0, (S|L|C|V|SY|)
> FE READ UNCORRECTED BLOCKS: : Operation not supported
> Signal=61952, Verror=0, SNR=57681dB, BlockErrors=0, (S|L|C|V|SY|)
> ^C
> [vortexbox.lan ~]# dvbtune -f 1183000 -s 22500 -p h -m 2>/dev/null &
> [1] 17061
> [vortexbox.lan ~]# scandvb -c -U
> using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0'
> 0x0000 0x0775: pmt_pid 0x0111 Television New Zealand -- TV ONE (running)
> 0x0000 0x0401: pmt_pid 0x010a Maori Television Service -- Maori TV (running)
> 0x0000 0x040b: pmt_pid 0x010d Television New Zealand -- TV ONE (running)
> 0x0000 0x040c: pmt_pid 0x010e Television New Zealand -- TV2 (running)
> 0x0000 0x0776: pmt_pid 0x010f Television New Zealand -- TV ONE (running)
> 0x0000 0x040e: pmt_pid 0x0110 Television New Zealand -- TVNZ 7 (running)
> 0x0000 0x0774: pmt_pid 0x010c Television New Zealand Ltd. -- TV ONE (running)
> 0x0000 0x0770: pmt_pid 0x010b Television New Zealand -- U (running)
> 0x0000 0x233e: pmt_pid 0x0056 SKY -- TS 22 IEPG DATA SERVICE (running)
> dumping lists (10 services)
> Maori TV (0x0401) 01: PCR == V V 0x0202 A 0x028c
> TV ONE (0x040b) 01: PCR == V V 0x0203 A 0x028d
> 0x0297 (ita) TT 0x0243
> TV2 (0x040c) 01: PCR == V V 0x0204 A 0x028e
> TT 0x0244
> TVNZ 7 (0x040e) 01: PCR == V V 0x0206 A 0x0290
> TT 0x0246
> U (0x0770) 01: PCR == V V 0x0200 A 0x028a
> TT 0x0245
> TV ONE (0x0774) 01: PCR == V V 0x0207 A 0x0291
> TT 0x0243
> TV ONE (0x0775) 01: PCR == V V 0x0201 A 0x028b
> TT 0x0243
> TV ONE (0x0776) 01: PCR == V V 0x0205 A 0x028f
> TT 0x0243
> TS 22 IEPG DATA SERVICE (0x233e) 83:
> [000-fffe] (0xfffe) 00: PCR 0x1fff
> Done.
> [vortexbox.lan ~]# fg
> dvbtune -f 1183000 -s 22500 -p h -m 2> /dev/null
> ^C
> [vortexbox.lan ~]#
>
> _______________________________________________
> linux-dvb users mailing list
> For V4L/DVB development, please use instead linux-media@vger.kernel.org
> linux-dvb@linuxtv.org
> http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
next prev parent reply other threads:[~2011-04-30 9:26 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-04-30 9:05 [linux-dvb] Optus D1 tuning? Morgan Read
2011-04-30 9:16 ` Stu Fleming [this message]
2011-04-30 11:16 ` Morgan Read
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1304154990.3962.48.camel@media-centre \
--to=stewart@wic.co.nz \
--cc=linux-media@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox