Re: [linux-dvb] [vdr] VDR 1.7.0 & multiproto & hvr4000 -> multiproto_plus

From: Gregoire Favre <gregoire.favre@gmail.com>
To: VDR Mailing List <vdr@linuxtv.org>, linux-dvb@linuxtv.org
Cc: Manu Abraham <abraham.manu@gmail.com>
Subject: Re: [linux-dvb] [vdr] VDR 1.7.0 & multiproto & hvr4000 -> multiproto_plus
Date: Fri, 2 May 2008 18:40:53 +0200	[thread overview]
Message-ID: <20080502164053.GA6397@gmail.com> (raw)
In-Reply-To: <481B3D85.2060204@lycosxxl.de>

[-- Attachment #1: Type: text/plain, Size: 997 bytes --]

On Fri, May 02, 2008 at 06:12:53PM +0200, Lars Bläser wrote:

> > Have you replaced linux/include/linux/compiler.h with the one from your
> > kernel ? (in multiproto_plus dir) if that's going to be included, this
> > shouldn't be in of course.
> 
> your patch included the compiler.h, after replacing it with the right
> one the drivers are build
> your patch also created a .config.old in v4l and the cx88 modules are
> not build (the .config created during make does only contain inaktive
> lines for cx88 modules), i modified the .config manual and started make
> again

OK, here's one without compiler.h and without .config.old (by the way, I
don't understand why make distclean didn't remove it...).

Good new, such way the patch is even smaller, so it would be really good
to have it included finally into the repo :-)

Any objection to the inclusion ?
-- 
Grégoire FAVRE  http://gregoire.favre.googlepages.com  http://www.gnupg.org
               http://picasaweb.google.com/Gregoire.Favre

[-- Attachment #2: Add full HVR-4000 support into multiproto_plus --]
[-- Type: application/octet-stream, Size: 16904 bytes --]

[-- Attachment #3: Type: text/plain, Size: 150 bytes --]

_______________________________________________
linux-dvb mailing list
linux-dvb@linuxtv.org
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb