PCTV 310c again

PCTV 310c again

[stef]

	Hello,

	while trying to have my PCTV 310c working for the SECAM-L analog channels I 
receive, I noticed that the module is allways trying to load MTS firmwares 
(see log below). But extract_xc3028.pl doesn't create MTS firmwares for 
SECAM-L. So no firmware is found and analog doesn't work.
	By adding the 310c id next to the CX88_BOARD_PROLINK_PV_8000GT in the switch 
within cx88_setup_xc3028() to force to non-mts firmwares, I got analog 
SECAM-L working. I know this isn't the right fix, and I hope that someone 
will come with a better solution.

Regards,
	Stef

dmesg of failed firmware load:
cx88[0]/0: AUD_STATUS: 0x32 [mono/no pilot] ctl=A2_FORCE_MONO1
xc2028 6-0061: load_firmware called
xc2028 6-0061: seek_firmware called, want type=BASE F8MHZ MTS (7), id 
0000000000000000.
xc2028 6-0061: Found firmware for type=BASE F8MHZ MTS (7), id 
0000000000000000.
xc2028 6-0061: Loading firmware for type=BASE F8MHZ MTS (7), id 
0000000000000000.
cx88[0]: Calling XC2028/3028 callback
cx88[0]: setting GPIO to TV!
xc2028 6-0061: Load init1 firmware, if exists
xc2028 6-0061: load_firmware called
xc2028 6-0061: seek_firmware called, want type=BASE INIT1 F8MHZ MTS (4007), id 
0000000000000000.
xc2028 6-0061: Can't find firmware for type=BASE INIT1 F8MHZ MTS (4007), id 
0000000000000000.
xc2028 6-0061: load_firmware called
xc2028 6-0061: seek_firmware called, want type=BASE INIT1 MTS (4005), id 
0000000000000000.
xc2028 6-0061: Can't find firmware for type=BASE INIT1 MTS (4005), id 
0000000000000000.
xc2028 6-0061: load_firmware called
xc2028 6-0061: seek_firmware called, want type=F8MHZ MTS (6), id 
0000000000400000.
xc2028 6-0061: Can't find firmware for type=MTS (4), id 0000000000400000.
xc2028 6-0061: load_firmware called
xc2028 6-0061: seek_firmware called, want type=MTS (4), id 0000000000400000.
xc2028 6-0061: Can't find firmware for type=MTS (4), id 0000000000400000.
cx88[0]/0: set_audio_standard_A2 AM-L (status: devel)
cx88[0]/0: set_audio_standard_NICAM SECAM-L NICAM (status: devel)
cx88[0]/0: start nicam autodetect.
cx88[0]/0: nicam is not detected.
cx88[0]/0: set_audio_standard_A2 AM-L (status: devel)

--
video4linux-list mailing list
Unsubscribe mailto:video4linux-list-request@redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list